UNSOLVED

Perseo_37bdd2

updated

15 years ago

0

2762

July 13th, 2011 21:00

How configure cge ports on VNX 5300?

I tried to configure with other blogs help, but the port still doesn't responde when I send a ping.

I follow the instructions below but my problem continue.

1.   Configure physical interface speed/duplex , create Logical interface  with parameters (IP address, mask) for Data Mover.

a.  In Top navigation bar , click “system” -> select “Network” -> Select  “devices” tab.

b.  Right-click device name “cge0” for server2 , select  “Properties,” set Physical device cge0’s Speed and duplex. Then click OK.

c.  Click the “Interface” tab, click “Create,” in pop-up window, select  “server2” and “cge0,”  enter “device name.”  “IP address” and “subnet mask,” and  then click OK.

2.  Configure the default gateway for the Data Mover

a.  In the Network pane, click “Route” tab, and click “Create.”

b.  Select the Data Mover (for example, server2), and enter destination “0.0.0.0.”

c.  Enter the Gateway‘s IP address

3. Configure the NIS server for the Data Mover

a. Under Network  task pane, click “Manage NIS Setting.”

b. Select the Data Mover name that you want to be set.

c. Enter the “NIS Domain Name.”

d. Enter the “NIS IP Address.”

4.  Configure the DNS server for the Data Mover

a.  Under Network  task pane, click “Create DNS Domain.”

b.  Select the Data Mover name that you want to set.

c   Enter the “DNS Domain Name.”

d.  Enter the “DNS IP Address.”

5.  Configure NTP server for the Data Mover

a. In the top navigation bar, click “system” -> select  “Data Mover” -> Select “server2,” right-click, and select “Properties.”

b. In the pop-up window, enter the NTP server IP address.

Thank you in advance.

  • Rainer_EMC

    6 Operator

    •

    8645 Posts

    584

    1

    Posted July 13th, 2011 23:00

    That should work

    Are you sure you cabled the correct port?

    Do a "server_log server_2 -f" and unplug and replug the cable to see if you are getting link up / down messages in the log

    You can also use server_ifconfig and server_sysconfig to troubleshoot

    With server_ping you can test if outgoing works

    Rainer

  • 584

    0

    Posted July 14th, 2011 11:00

    Thank you for your help, I check all my configurations again and my problem was resolved when I erease the vlan number.

  • Rainer_EMC

    6 Operator

    •

    8645 Posts

    584

    0

    Posted July 14th, 2011 12:00

    Makes sense