sirsep

updated

7 months ago

S

sirsep

2 Intern

•

10 Posts

•

3 Points

0

408

April 21st, 2026 05:23

Aurora R13, severe 400MHz throttle (False BD PROCHOT) — RTX 3080 starved

Hey everyone, seeing if anyone else has gone down this exact rabbit hole with their R13

So first see this thread:

https://www.dell.com/community/en/conversations/alienware-desktops/aurora-r13-huge-fps-dropsstuttering-in-all-games-even-after-removing-awcc-and-sa/69c426383751104d27802798

The Specs Aurora R13, i7-12700F, OEM RTX 3080 10GB, 64GB DDR5

The Problem For a long time, across multiple games like Warzone and Total War, my system will run fine and then suddenly collapse into 8-13 FPS with insane frametime spikes. GPU usage plummets to like 10%

The Diagnosis After days of logging telemetry, stripping out audio drivers, fixing NVMe pagefaults, and running DDU, I finally found the absolute root cause using ThrottleStop.

When the FPS collapses, the CPU clock speed hard-locks at exactly 398MHz (0.4 GHz). ThrottleStop Limit Reasons shows it’s being triggered by BD PROCHOT and EDP OTHER.

Here’s the catch: the CPU is sitting at a freezing 44°C and only pulling 14.9W when this limit triggers. The CPU is completely fine, but the Dell motherboard VRMs (or the PSU) are sending a false panic signal, choking the processor and completely starving the 3080

Since Dell hard-locks the BIOS, ThrottleStop has the BD PROCHOT box grayed out, so I can't even force the software to ignore the broken sensor

Next Steps I’m done tearing my hair out tomorrow I’m planning to do a hard EC reset (holding power for 60s unplugged), run the Dell pre-boot F12 diagnostics to see if it catches a dead VRM thermistor, and completely reseat the 24-pin and 8-pin cables on the board (I'm not hopeful)

Has anyone else dealt with a false BD PROCHOT on these proprietary Dell boards? Did an EC reset or cable reseat actually fix it for you, or did you have to fully replace the motherboard/PSU?

(edited)