I put an NVMe drive on a card in slot 4 and it runs fast. The R10 has PCIe 3.0 lanes with a total of 10 available, so the NVMe uses four in the four slot. The slot next to it has one lane, but the system supports only two NVMe drives max. Many systems only support one NVMe drive.
Instead of adding a third NVMe which is NOT supported by the R10, I added a SATA III drive in a 2.5 inch drive slot. Since I didn't get a spin drive in the 3.5 in drive bay, I repurposed the 3.5 inch bay SATA cable to the nearest 2.5 drive bay. The power connector was already stashed out of the way in that bay. A SATA III SSD is slower that NVMe, but is way faster than I need.
That's not technically correct. The R10 only supports 2 NVME drives because of the lane limits that's it, any board that has 4 lanes+ to the PCIE slots will run an NVME drive through a pcie adaptor card. Boards that say 1 supported NVME drive is because they only have one m.2 slot not that you can't run more through an adapter. R10 just was not designed that way at all being very minimal it has pretty lackluster PCIE slots for add on cards
Vanadiel
8 Professor
•
7094 Posts
•
29695 Points
650
0
Posted November 3rd, 2021 17:00
Pending on the video card, only slot 4 is available as the remainder is covered by the video card.
To ensure we have the numbering of the slots correct, item #15 on this schematic is slot #4: R10 motherboard layout
You should be able to install an M2 drive in slot #9.
If you already have on M2 installed, and a second 2 TB M2 using an adaptor, I am not sure why you would want a third one to use as a cache drive?