Need FDD driver for USB External drive with Win 98
I recently acquired a Latitude CPx J. It came with a CD-ROM drive and no floppy but I already had an external USB FDD for my wife's HP laptop so no problem, I thought. It works fine on her HP running XP and on my Dell desktop running 2000, but the Latitude running 98 demands a driver. I see all kinds of references to all kinds of drivers but I've looked all over the site and I can't find the actual driver I need. At least not in recognizable form. Can someone point me in the right direction? Thanks
This drive came bare in an envelope with no documentation. On the drive itself there is no line that says Model No. It has ASM P/N: 27L4226 and FRU P/N: 05K9283. Below that in larger type is N533. In a little box with some Chinese characters it has 3892D 223. When it comes up in a dialogue box in Windows it says Mitsumi USB FDD 061M. No doubt the brand is Mitsumi, but if you can figure out which is the model number you are doing very well. Thank you for your help and interest.
Message Edited by Barney Five on 07-22-200608:42 PM
Hey, Chief, I found the driver and downloaded it, and after a few false starts I got it installed. It recognizes the FDD as Drive E, but it says my disk is unformatted. I try to format a disk on it and it says it can't. Basically, even though it sees the drive, it seems like it isn't reading it. The drive still works on 2000 and XP, so the problem isn't the drive. It acts like the driver isn't written correctly to talk to 98. Would I be correct in assuming there would be no one else interested in writing drivers for Mitsumi? I don't have an internet card for the Latiitude yet so I downloaded the driver to my desktop, burned it to a CD and copied onto the Latitude before I could install it. Would that make any difference? The Wizard seemed to be reasonably happy with it once I figured out how to tell it where to find the driver. Thanks for your help.
Well, I tried two or three of them, but I don't know enough about these things to bypass the automatic Windows junk. I poke Setup for a driver and it says it did the setup. But when I restart, Windows does its thing and installs all the old stuff again. And it still says the disks are unformatted and unreadable. I think my only salvation will be to wait till I can afford to buy 2000 or XP and get past all that. Thanks.
mombodog
2 Intern
•
12735 Posts
1445
0
Posted July 21st, 2006 23:00