
UNSOLVED
VNX 5300 upgrade from 1G iSCSI to 10G iSCSI
Current environment:
- 2 HP 2810's (1G iSCSI) linked together with 4G LACP static trunk
- VNX 5300 (block only)
- Jumbo enabled
- Both 2810's are on the same subnet 192.168.1.x/24
What I would like to switch to:
- 2 HP 5406zl or 5412zl with 10G ethernet modules -- Linking would be a 20G static LACP trunk between SPA and SPB
- Upgrade VMware environment from 1G to 10G
- Keep block only on the VNX5300
- Enable Jumbo Frames...of course
The current setup has both SPA and SPB on the same subnet. I would like to switch that so SPA and SPB are on different subnets with a aggregated trunk connecting both switches.
Questions:
- Should I keep SPA and SPB on the same subnet? Or create two different subnets? (The reason for this question is that I was reading about powerpath for Windows and if both SPA and SPB are on the same subnet...powerpath is kindof useless...if I read EMC's doc's correctly.)
Responses (1)
Solutions (0)

dynamox
11 Legend
•
20419 Posts
•
87439 Points
277
0
Posted December 10th, 2012 20:00
take a look at this article
emc245445