SpinalTap

updated

17 years ago

S

SpinalTap

19 Posts

0

6545

September 10th, 2009 07:00

IT Assistant won't see Powervault MD3000

Hello all,

We've recently added an MD3000 to one of our Poweredge 2950 servers.  Array works great, no issues there.  However, our IT Assistant server won't classify the unit as a Powervault device, instead it's in the Unknown category.  Using the Troubleshooing Tool, the MD3000:

  • Passes the Ping test.
  • Fails the SNMP test - Errors are:  failed to Set, failed to get, and "Unable to detect presence of agent software."  I have triple-checked the community strings.
  • Fails the Powervault connectivity test with the message "Unable to connect; unsupported firmware detected on the Powervault MD Array."

ITA is v8.2, and the array contollers' firmware is at 07.35.22.61 - the latest.  MD Storage Management Client software is installed on the ITA box, and sees the array just fine.  There are no firewalls in between the ITA box and the array, and I've disabled Symantec Endpoint Protection on the ITA box. 

Any ideas?  Thanks in advance.

  • DELL-Jeff M

    2 Intern

    •

    793 Posts

    613

    1

    Posted September 10th, 2009 16:00

    Thanks for posting!  Your ITA is a little old, I think 8.5 is the latest version, so you might want to update it.  Your tests indicate that the MD3000 is not communicating via SNMP.  You should go into the configuration utility for it and set the SNMP community string (which is case sensitive), and the destination IP address.  Most likely that will fix the problem.  I'm pretty sure the MD3000 includes an SNMP agent, but bear in mind that some devices don't have one, so they can only show up as Unknown in IT Assistant.

  • SpinalTap

    19 Posts

    613

    0

    Posted September 16th, 2009 09:00

    Jeff,

    Upgrading ITA to the latest (8.5) did the trick.  Thanks for the tip!

    Mike