sorry, i don't remember if you have to use -tgt for restore ...i typically use device files for clone operations. That should be easy to test though with a pair of un-used devices.
after restore is complete you will need to run "symclone split" to be able to run "symclone recreate" again.
Reply to this message by replying to this email -or- go to the message on ECN ( https://community.emc.com/message/509556#509556 )
Start a new discussion in Symmetrix by email ( mailto:discussions-community-support-symmetrix@emc-developer.hosted.jivesoftware.com ) or at ECN ( https://community.emc.com/choose-container!input.jspa?contentType=1&containerType=14&container=2449 )
dynamox
11 Legend
•
20419 Posts
•
87439 Points
1593
0
Posted October 27th, 2010 15:00
yes, your symclone has to be in activated state, and the actual device state should be "Copied". The command to restore is:
symclone -g restore
after restore is complete you will need to run "symclone split" to be able to run "symclone recreate" again.