UNSOLVED

Alex2x

updated

22 years ago

A

Alex2x

17 Posts

0

5356

October 30th, 2004 11:00

Slave Drive

I recently added a second hardidk to my computer, my jumper setting are ok but somtimes wh i start the computer it says it cannot detect the second drive and i have to press F1 to carry on or F2 to enter the Bios. If I choose to press F1 and carry on windows starts and it detect the drive but , for tsome reason the bio's doesnt. any help please.
  • osprey4

    6 Operator

    •

    34230 Posts

    157

    0

    Posted October 30th, 2004 13:00

    Check your connections, power and IDE. Go into the BIOS and set the primary slave to none, reboot and reset it to auto and reboot again.
  • 157

    0

    Posted November 1st, 2004 12:00

    I have the same problem.

    I have a Dell 8300 with Bios Version A07.  No matter what I do, the PC Bios will not recognize a Western Digital Caviar IDE drive.

    I've tried it on both IDE Ports, as both Master and Slave.  No dice.  The Bios will not see it (F1 to continue, F2 to enter setup).   If you leave it set to Auto, and bypass the errror with F1, then Windows still sees it.

    It's not the power or IDE cables (or jumper settings).  I've tried different power connections, different IDE cables, and even used the same connections that the DVD-ROM drive used (in case I had multiple sets of bad cables).   Same symptoms.

    My 8300 also has one SATA drive installed.  My best guess is that the BIOS is simply not going to let me use this IDE drive.   I have not tried disconnecting the SATA drive to see if this is the issue (BIOS refuses to allow both SATA and IDE hard drives in the same box).

  • Alex2x

    17 Posts

    157

    0

    Posted November 1st, 2004 14:00

    Have you tryed to reset the bio's with the jumper setting on the motherboard.
  • JRosenfeld

    2 Intern

    •

    4383 Posts

    157

    0

    Posted November 1st, 2004 20:00

    Not sure if this is relevant, but the Seagate install SATA drive instruction shows a different jumper setting if a second slave drive is non ATA compatible
     
     
    So you might try resetting the jumper on your primary SATA drive

    Message Edited by JRosenfeld on 11-01-2004 10:26 PM