UNSOLVED

vic5014

updated

18 years ago

V

vic5014

56 Posts

0

11878

July 31st, 2008 06:00

hard drive upgrade for dimension 8300

I want to upgrade the hard drive on my dimension 8300, but I discovered that removing either drive (I have 2 160gb hdds) results in the system refusing to boot windows. What should I do? I had to reinstall windows once, but did it over the exsisting install because I did not want to reformat the drive and lose my data. Could this be the cause? I have noticed that both drive seem to have system restore files on them.
  • tr4

    1 Rookie

    •

    1727 Posts

    354

    0

    Posted August 1st, 2008 00:00

    Is you c: drive 160 or 320? You seem to have a raid configuration if you are cannot remove the drive from the middle of the cable. If you are removing the drive from the end, you cannot expect it to boot
  • vic5014

    56 Posts

    354

    0

    Posted August 1st, 2008 17:00

    No, it's not a RAID. the drives are from different manufacturers; one' s a seagate, the other a wd. I'm trying to remove the secondary drive and copy everything on the boot drive, but I get an error message saying the computer won't boot windows.
    Message Edited by vic5014 on 08-01-2008 01:49 PM
  • tr4

    1 Rookie

    •

    1727 Posts

    354

    0

    Posted August 2nd, 2008 00:00

    You can raid with drives from different manufacturers. Even different sizes. So the drives show up with different letters in explorer?
  • vic5014

    56 Posts

    354

    0

    Posted August 2nd, 2008 04:00

    Are you absolutely sure you can? Anyway, the drives are configured as just two separate disks with different drive letters, unless the computer set up a raid on its own.
  • tr4

    1 Rookie

    •

    1727 Posts

    354

    0

    Posted August 2nd, 2008 15:00

    In raid the drives have to be the same size, the smallest of the drives is what both will be. If you raid a 160 with a 320, the 320 would act like a 160.

    Maybe your solution is to get your newe drive and install it by itself. After windows is done, you can hook up one of the drives and copy all your data to the new one, then unhook the old one and hook up the other old one and do the same. Then you can remove it or reformat it as a data drive.

    If I could tell for sure, I may change my approach but it seems like this would be the safest 

  • vic5014

    56 Posts

    354

    0

    Posted August 2nd, 2008 17:00

    that's my plan. the problem is that if I remove either drive, the computer refuses to boot.
  • tr4

    1 Rookie

    •

    1727 Posts

    354

    0

    Posted August 2nd, 2008 18:00

    Boot of of the reinstallation cd
  • vic5014

    56 Posts

    354

    0

    Posted August 2nd, 2008 23:00

    I figured I'd probably have to do that, but was wondering if anyone knew of another way.