UNSOLVED

jaywv0489

updated

22 years ago

J

jaywv0489

1 Rookie

•

3 Posts

0

30333

February 17th, 2005 18:00

5100cn load tray letter

New 5100cn, won't print from tray1.  MFP works fine, but each time we try to print from tray1 it fails.
 
Plain1
Tray is on 8.5 and 11 (checked 4 times).
Good paper stock (tried full, tried half full, tried 20 pages - paper seals broken to aid feediing).
Driver is setup right on the network.
 
Nothing jammed.
 
Need help. 
  • jaywv0489

    1 Rookie

    •

    3 Posts

    408

    0

    Posted February 18th, 2005 18:00

    Thanks Chris

     

    After an exhausting 2 hours on the phone with Dell,  they believe the tray scensor is bad and they are sending me a new printer.

  • chrilles78

    46 Posts

    408

    0

    Posted February 18th, 2005 18:00

    Hi,

    What kind of paper are you using? This is a setting that hasn't correctly been configured. My best advice is to check the printer first, by printing a testpage from the printer which gives you the info about the settings. Can you print a testpage from tray 1? If yes, then it's pure down to the driver. If not, then the setting on the printer isn't correct.

    In the driver there are a few settings for setting the papersize as well. Check this and if you still cannot figure it out let me know and I will do my best to help you.

    Regards,

    Chris

  • chrilles78

    46 Posts

    408

    0

    Posted February 18th, 2005 19:00

    No problems. I still don't think it's a hardware failure but somewhere in the settings.

    You can't print a testpage either from the printer from tray 1?

  • 408

    0

    Posted March 24th, 2005 15:00

    Remove the tray; on the inside right hand side there is a thin black plastic piece that slides back and forth; look at the right side of the gray paper guide; there is a round knob like piece on there; lift it up and put it in the groove of the black piece;that should make that error go away
  • 408

    0

    Posted June 10th, 2005 19:00

    Any luck getting this problem solved?

     

  • WonderingAloud

    1 Rookie

    •

    58 Posts

    408

    0

    Posted September 3rd, 2006 13:00

    Brilliant!  That fixed mine!  I had just taken the thing out of the box and was trying to set it up and kept getting told that I had 8 X13 paper in the tray when it was 8 X 10.5.  Sure enough the slider wasn't in the groove.

     

    I had just purchased this printer as a refurb from the outlet. Thought I was hosed. Thanks for pointing me in the right direction! :smileywink:

     

    Mike

    Message Edited by WonderingAloud on 09-03-200609:56 AM