INSTRUCTIONS FOR CLEANING THE GLASS ON THE DELL 1600n MFP
Generally the plastic on the printer needs to come off; unplug all cords; need small phillips head screw driver.
Remove the paper tray and toner cartridge and set to the side out of the way.
Remove the four recessed screws on the back side and remove the panel.
Remove the four recessed screws & four visible screws on the front side. These screws are behind the toner access panel & previously removed paper tray. Four screws each on the left and right sides when looking at it from the front.
Place printer on its right side to remove one screw on the left side panel; the screw is accessed near the back and bottom.
Remove left panel by lifting up on the three tabs that lock on the bottom. The left panel is lifted/tilted from the bottom by the tabs to the top; a little wiggling should break it free. Unplug speaker wire from circuit board.
Place printer on its left side.
Remove right panel by lifting up on the three tabs that lock on the bottom. The right panel is lifted/tilted from the bottom by the tabs to the top; a little wiggling should break it free.
Remove front display panel cover by lifting up on the lip on the front edge. The front display panel cover is lifted/tilted from the front; a little wiggling should break it free.
Remove the three recessed screws on the lower front side of the front display panel. The front display panel is lifted/tilted from the front; a little wiggling should break it free.
Remove paper clip panel cover on the far left of the front display panel.
Remove top pivoting cover that sits over scanner. This lifts out on the top rear.
Remove the two screws on the top front side of the glass panel assembly.
Remove the two recessed screws on the top back side of the glass panel assembly.
Lift off the glass panel assembly; use fingers along left and right edges to tilt the assembly up; a little wiggling should break it free.
Clean all the glass surface with a good cloth towel (lint free) and a foaming glass cleaner.
Reverse the order to put back together; take your time and be careful. Good Luck!!
fishhead_soup
6 Posts
159
0
Posted November 11th, 2007 14:00
I tried to post a link to the solution, but the link was deleted.
Check you PM.
Regards
Rick