I've searched through the forum's history and have found different answers to what types of drives can be used in the PE 2900 with a Perc 5/i integrated controller.
1. Can SAS and SATA drives be used on the same system?
2. If SAS and SATA drives can be used can a hot spare of each type be setup? Will the Perc select the correct hot spare if there is a failure?
3. I assume that SAS and SATA drives can not be mixed in the same virtual array. Is this true?
4. Can SATA drives be used in the 2x drive bay?
5. When using SATA drives is it necessary to use an "interposer card"?
6. If the 2900 is ordered with SATA drives what type of drive ships? Are interposer cards used?
More of you are suppose to. You could just put the SATA drive in the SAS spot on the hard drive carrier and it will connect to the backplane and work without issue. The interposer board has the two different connections for the data and the cable, but the slot on the backplane will provide both. I would use the interpose board though.
at5147
884 Posts
143
0
Posted October 30th, 2007 14:00
2. I would assign a dedicated hotspare, but a SATA drive will not rebuild into a SAS VD.
3. Correct.
4. Yes.
5. Technically no, but you should.
5. SATA drives, and yes.