UNSOLVED

bench12345

updated

21 years ago

B

bench12345

1 Message

0

8448

January 31st, 2006 16:00

CERC SATA1.5/6ch can't hot swap?

I've recently acquired 2 of these dell-branded adaptec 2610sa cards, and installed them in two generic, non-dell machines. Now when I go to try to hotswap drives out of an array on either card, things don't work so well. It appears that I can yank a drive and my arrays degrade just fine, but when I put a drive back in, the raid card doesn't see it until I reboot, even though the backplane spins up the drive just fine.
 
Even if I use afacli to explicitly tell the controller to rescan its bus, it still doesn't see the newly added drive. Diagnostic logs show the scan simply doesn't see the drive. Once I reboot the box, the drive shows up just fine.
 
I suspect that this may be due to the fact that the controller wants to talk to an enclosure, and my Brand X backplane (technically a NORCO-LIB700) doesn't support the same features that the backplane in the Dell machines use. Still, you'd think that if the drive was spinning, the controller should see it.
 
I'm running the most recent firmare (7417).
  • dcmbrown

    15 Posts

    124

    0

    Posted February 24th, 2006 03:00

    I have a pair of PowerEdge 1800 servers using the CERC 6 channel cards with which I am using to hotswap under Fedora FC 4 using the aacraid kernel module. I have been hot swapping these drives using single removable enclosures for a couple of months now at least once per week. (RAID 1 with several extra removable drives for near instantaneous installation into another server should the need arise)

    I've been using SNT-135 SATA removable racks which have so far proven very sturdy. They use the SATA connectors on the drives themselves to connect to the single rack backplane. The only downside is that you have to connect an extra wire to get the drive light to run.
    http://www.snt.com.tw/product.php?mode=show&cid=5&pid=73

    Of course today one of the CERC cards appears to have failed and messed up an array... but that's another story I don't think is related to this.