UNSOLVED

phippsinc

updated

21 years ago

P

phippsinc

4 Posts

0

13202

June 20th, 2005 21:00

Added new drive to scsi, but on wrong virtual drive group

I currently have a PowerEdge 2600 with PERC raid controller. It has 5 scsi drives installed. One virtual disk has two drives in a RAID 1 config, the other virtual disk has 3 drives as a RAID 5 array.
 
I installed a 6th drive today and it will ONLY allow me to add it to virtual disk #1. Is there any way I can "force" the drive to be added to virtual disk #2?
  • warwizard55

    720 Posts

    430

    0

    Posted June 21st, 2005 15:00

    phippsinc,

       Assuming all the drives are the same size, you might look at the drive F/W, I've see a few procedures to force the drive to be slightly bigger... look at the block count on the drives the new one needs to have as many or more blocks as the ones in the existing array. Reply if the F/W does not help and I'll try to find the remembered procedure.

    warwizard DCSP

  • phippsinc

    4 Posts

    430

    0

    Posted June 21st, 2005 15:00

    I did not explain myself very well. All the drives are the same size. The scsi RAID controller has two channels.  I guess I need to know how to move a drive from channel 0 to channel 1.
  • warwizard55

    720 Posts

    430

    0

    Posted June 21st, 2005 16:00

    phippsinc,

      Ok that's a different issue. The PE2600 has three different ways to use two channels.

    1) External media bay drives on Ch 0 (only two drives allowed) and main bay with 6 drives on CH 1

    2) Split BP in the main bay, ID 0,1,2 on Ch 0 and ID 3,4,and 5 on CH 1

    3) Main BP on CH 0 with 6 drives, external drive enclosure on CH 1 with up to (8, 12, or 14 drives depending on which PV is used).

    I suspect that you have configuration #2 above with the new drive being installed at ID#2. In that case you'll need to disconnect the SCSI cable connecting to SCSI B on the backplane daughter card. This will have the controller treat the BP as a 1x6, and you can then add the 4th drive to your RAID 5 without having the array split between the two backplanes (a bad thing for a RAID 5).

    warwizard DCSP

  • phippsinc

    4 Posts

    430

    0

    Posted June 21st, 2005 16:00

    You are right about config. #2 as you stated.

    If I disconnect the B cable, I would guess that I would have to reconfigure my existing virtual drives (Drive "C" is raid 1, drive "D" is raid 5) from scratch and then restore everything from tape. I am trying to avoid having to do that. But if that's what I have to do...

  • warwizard55

    720 Posts

    430

    0

    Posted June 21st, 2005 19:00

    phippsinc,

     

      No you would not have to do anything of the sort, the hard drives can be shuffeled around and the controller would be able to handle it as the RAID array info resides on the drives as well as the controller. Just make the changes as I said and you will be able to do the reconfiguration of your RAID 5. Watch out, the reconfiguration defaults to RAID 0, you'll need to manually select RAID 5.

    Disclaimer: Allways back up your data before making reconfigurations to your RAID system, it's your data, and your job!

    warwizard DCSP