UNSOLVED

KGB1

updated

19 years ago

K

KGB1

4 Posts

0

7888

August 8th, 2007 04:00

Problem connecting PS3 to 2407WFP through Component

Hi, I purchased a Sony component cable in order to hook my PS3 up to my 2407WFP monitor and I'm having problems. When I hooked it up, I reset the PS3 display settings by holding the power on button, then started the PS3 and nothing would show on the screen. I hooked up the component cables to a TV and it was working fine. The revision of the monitor is A03. I don't want to get a HDMI-DVI cable because I don't like switching cables as I also use it as my main display for my PC. Also, picture-in-picture is another important reason why I want component.

Any help would be greatly appreciated.

Thanks in advance.

Message Edited by KGB1 on 08-08-2007 12:40 AM
  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    215

    0

    Posted August 8th, 2007 13:00

    KGB1,

    So, the PS3 + Sony component cable + TV work.

    * Power off the monitor
    * Disconnect all cabling from the bottom and/or sides of the monitor (especially the power cord). Disconnecting the power cord releases all circuit latches "resetting" them
    * Press and hold the monitor power button down for 5 seconds
    * Reconnect only the monitor power cord and either the #1 blue VGA or #2 white DVI (not both)
    * Power on the monitor
    * The PC should already be on. The monitor should auto sense the #1 blue VGA or #2 white DVI. If it does not, press the Input Select button and change to #1 VGA or #2 DVI
    * Reconnect your device to the monitor components
    * Power on that device
    * Press the Input button and switch to the component setting


    DELL-Chris M (old account)

    #IWork4Dell

  • KGB1

    4 Posts

    215

    0

    Posted August 9th, 2007 17:00

    Thanks Chris, that worked like a charm!

    On another topic though, when I go to set my resolution as 1080i, it works, but the screen flickers like an old CRT and the quality is worse than 720p. When I switch it back to 720p, the flickering goes away and I get a nice solid, high quality picture. I thought 1080i was supported through component, what gives?

    Thanks again.
  • radxge2

    1 Rookie

    •

    77 Posts

    215

    0

    Posted August 10th, 2007 01:00

    The 2407wfp-HC do not have deinterlacing filters. This explains why 480i and 1080i do not look good. AFAIK, there is nothing you can do!
  • KGB1

    4 Posts

    215

    0

    Posted August 10th, 2007 02:00

    Looking back at all of the documentation that came with the monitor, I was able to determine that it's a 2407WFP, not 2407WFP-HC. 480i, 480p, and 720p all don't flicker by the way - just 1080i. Thanks for your input though.