2007FP freezes when i try to install the usb port?
If i try to install the USB port into my monitor the screen freezes and i have to reset. Upon reset windows will not load.
This goes away if i just remove the usb cable. What gives? Why wont the USB work?
I can even just plug in the USB before I turn on the computer and it freezes on the windows loading screen. Once again i can just turn it off again, remove the cable, and it works fine.
The reason for my inquiry is that with W98se, any attempt to use the USB would freeze the PC at Shutdown or Restart, leaving the PC dead in the water at the Windows splash screen. Only by applying C-A-D could I enable a (bad) shutdown. When the USB upstream cable was removed, all was fine.
By the same token, using the same USB 1.1 on my Win XP Pro is not a problem. This OS is in the same PC but situated in a second HD-D.
Your symptoms are somewhat similar, yet differ in that the OS will not load; this is the exact opposite to that which I experienced. In my case, there is no solution and the 2007FP USB is useless if I'm going to continue use of W98se.
As a matter of record, I experienced the same exact situation as I've described when using a Dell 1907FP as well
1) I'm fairly sure that the 'one-off' serial number on the rear of the Panel serves that purpose. It's an alphanumeric code which for example, looks something like this: CN-OCnnnn-nnnnn-nnN-nUCL -- where "n" equals a numerical value
2) LOL !!!! Good question. But here's the scoop --> Yeah, they're screened for T.o.S issues, but as far as I'm concerned, that's it ! If you get some direct help with a question regarding these Monitors (in this forum branch) it's a near miraculous occurrence.
The concept being that this is intended to be a peer-to-peer forum where users help each other out. Sounds good on paper, but it has been an utterly and totally useless waste of time for me.
I overlooked your reply that it's a fully updated XP platform. Well, sorry barcardi, I've no idea what it could be. You might want to swap out the USB cable and try that. Then if that fails, haul the monitor (and extra cable) over to another PC and see what comes of that.
Edit: and try plugging into all other free USB ports on the PC itself. You've probably already tried that though.
Message Edited by Captain Picky on 09-05-200607:56 PM
Captain Picky
38 Posts
1530
0
Posted September 5th, 2006 07:00
May I ask which Operating System is in use ?
The reason for my inquiry is that with W98se, any attempt to use the USB would freeze the PC at Shutdown or Restart, leaving the PC dead in the water at the Windows splash screen. Only by applying C-A-D could I enable a (bad) shutdown. When the USB upstream cable was removed, all was fine.
By the same token, using the same USB 1.1 on my Win XP Pro is not a problem. This OS is in the same PC but situated in a second HD-D.
Your symptoms are somewhat similar, yet differ in that the OS will not load; this is the exact opposite to that which I experienced. In my case, there is no solution and the 2007FP USB is useless if I'm going to continue use of W98se.
As a matter of record, I experienced the same exact situation as I've described when using a Dell 1907FP as well