UNSOLVED

sicre

updated

22 years ago

Closed

S

sicre

4 Posts

0

6893

August 2nd, 2004 08:00

Latitude 233 CPxJ no more boot

My CPxJ was in long term wait mode when the battery became empty.

Using a good supplier, now I can not boot :

Switching on the PC, the three green lights turn on, then the first on the left turn off after 2 seconds. The two others stay on during 3 to 4 seconds and all switch off, having nothing on the ecreen.

I tried to press Fn+F1 during this process, but nothing occured.

Do you thing that I have to flash the BIOS ?

If yes, how to proceed ?

 

  • bobotech

    6 Posts

    198

    0

    Posted August 2nd, 2004 14:00

    Most likely, its the unseated cpu issue that is very common with these older dell laptops.

    look here: http://forums.us.dell.com/supportforums/board/message?board.id=latit_general&message.id=36877

    Let us know if that works, i like reading followup postings that say if the problem was resovled.

     

  • sicre

    4 Posts

    198

    0

    Posted August 3rd, 2004 06:00

    Thanks for this answer.

    I just read it now, and I will test this potential solution today. I will give you a feedback.

  • sicre

    4 Posts

    198

    0

    Posted August 5th, 2004 07:00

    Bobotech

    I applied your advice following the link you gave me (thanks), and let me give you now a feedback following your request.

    The link said :

    "Well i did a  little searching on this forum and found out that a common cause of  this issue is the cpu not being properly seated in its location.

    So i went ahead and pulled the keybaord off, pulled the heat sink off and then reseated the cpu (the 3 screws holding the cpu down were tight)."

    I applied this recommendation and unfortunately,   powered my PC up it does not worked (no boot).

    The symptoms are the same :

    Powered it, the three green led turn on (Num , Alpha and Def), then after one second Num turn off.

    Alpha and Def remain on during 3 to 4 seconds, then the power turn off.

    Trying to apply the sequence Fn+F2 or others when powered up, no actions. 

    During this process, the screen remains black nothing appears.

    Let me give an indication more  :

    I do not heard the Hard Disk to start.

    Do you know if in the normal process, the HD must start first of all, or after this initial phase ?

    Thanks for your help.

     

     

  • sicre

    4 Posts

    198

    0

    Posted August 5th, 2004 07:00

    Proceeding my operations, I removed and I re-seat CPU and memory.

    But I read in the forum some advices asking to remove and reset CPU and memory.

    How can I reset CPU and memory ???

  • rob42386

    14 Posts

    198

    0

    Posted August 6th, 2004 05:00

    Ok, i bought a latitude cpm 233xt for 35 bucks last night, and sometimes it does the same thing yours is doing!!    Then sometimes it will start up!!  Also if i move it abruptly it will freeze up? does anyone know what it could be?   This is a annoying problem so free bump!!