
UNSOLVED
H
hargakanay
2 Posts
0
10957
September 25th, 2011 20:00
Diagnosis of 0F00:1332 - mainboard fault - second opinion? :)
Hello folks,
I'm having problems with my (out of warranty) Studio 1737 laptop. I think it's a mainboard error, but I was hoping someone could give me a second opinion before I spend the money on one. Here's my story/line of reasoning:
1) Windows 7 frequently hung when doing various things (e.g. launching Chrome; browsing photos with XBMC), prompting a restart.
2) Memtest identified a faulty RAM-stick, which I replaced.
3) Western Digital hard-drive diagnostic found bad sectors which I couldn't repair with the Western Digital utility, or with chkdsk /f. I concluded that the hard drive was getting ready to fail, so I removed it from the laptop, put it in a USB hard drive container, and backed it up using my desktop PC.
4) I ran the WD hard drive diagnostic again, with the drive in the hard drive container on my desktop PC. No problems were detected.
5) The system event log on the laptop showed the following errors numerous times:
The driver detected a controller error on \Device\Ide\IdePort0
The driver detected a controller error on \Device\Harddisk1\DR6
I assume that one of these is the hard drive and the other is the DVD-ROM drive - presumably they're accessed by a single (faulty?) controller on the mainboard.
6) I ran the Dell diagnostic utility (CW1367A0.exe) from a bootable USB stick, which repeatedly returned the error message
'Error code 0F00:1332 Msg: Disk - Block Interrupt Request (IRQ) did not set in time'
This happened many times over the space of a couple of hours, without any increase on the progress bar; eventually I turned the laptop off.
I think that the culprit is a faulty drive controller on the mainboard; if the drive was faulty, it wouldn't have passed the testing on my desktop PC. So I'm looking to buy a new mainboard. Does my reasoning seem sound? I don't want to shell the money out for a part that I don't need!
Thoughts and advice much appreciated - thank you in advance! :)
Responses (3)
Solutions (0)
hargakanay
2 Posts
265
0
Posted September 28th, 2011 19:00
Thanks, I can see the logic in that: easier and cheaper than replacing the mainboard. I imaged the old hard drive onto a new one, and installed it, but unfortunately I'm still having similar problems:
The system boots up, but runs quite slowly; the first time I tried to log into Windows it froze and I had to reboot. It logged in the second time, and detected/installed drivers for the new HDD. I rebooted/logged in, and ran the Western Digital hard drive utility. It passed a quick test; I left an extended one running overnight and came down the next morning to a reboot after a BSOD. (I don't know whether or not the HDD test completed before the crash.) I ran WhoCrashed on the minidump; I'm not at home at the moment, so I can't remember the exact message, but the gist was that, while ostensibly caused by the Windows kernel, a third-party driver, or hardware, may actually be to blame.
I checked the system event log, and I'm still getting numerous controller-related errors:
"The embedded controller (EC) did not respond within the specified timeout period."
"The driver detected a controller error on \Device\Ide\IdePort0."
I installed every driver/BIOS/utility update etc. offered on the Dell website for my notebook model; I think it's time to replace the mainboard, unless anyone has anything else to recommend?
Many thanks,
Ben.
Wish I could have posted my experience sooner for you but just last week I've run into similar problems. Vostro 220S. Started out with what looked like typical registry corruption - I think it was the "system" reg hive. I was prepared to restore an older version of the hives when the whole thing stopped booting. Running dell diags gave me the same 0F00:1332 error which seemed like a hard drive error. Called Dell, explained it to them and they agreed, sent a WD hdd. Now I tried loading the Vista recovery DVD onto the new hdd and I can't get through it, I get BSODs that are similar to when you don't have a controller driver properly loaded, etc. Correct me if I'm wrong, but the Dell restore DVD should not have to do the F6 driver load thing to properly load drivers. I did anyway - downloaded the controller drivers from support and loaded them at Windows setup f6 (I tried the Vista AND XP restore discs the PC came with) BSOD'd on both. I ran dell diagnostics with the brand new WD hdd attached and get the same IRQ error. It's got to be the motherboard.

ejn63
11 Legend
•
87469 Posts
•
321256 Points
265
0
Posted September 25th, 2011 20:00
I would not replace the mainboard before replacing the hard drive.