UNSOLVED

Einbauschrank

updated

19 years ago

Closed

0

3751

March 12th, 2008 20:00

AC Wattage cannot be determined on XPS 1330

I know this problem is generally due to the bad plug design and I already mailed technical support as I am abroad at the moment. But since they don't bother answering me I thought I might ventilate my anger. Is there a way to

a) circumvent the problem of performance loss?
b) prevent this from happening again?
c) will I have to do all the dumb stuff as all the others only to have the motherboard replaced afterwards?

If they know it's the motherboard why the hazzle?

Grrrr. It's frustrating to pay good money for a good looking and
decently running laptop only to have it thwarted by a stupid design.

Regards

Patrick
  • 7oby

    193 Posts

    272

    0

    Posted March 13th, 2008 06:00

    I do not at all understand your problem!

    Since you seem german, go to:
    1. Systemsteuerung / Verwaltung / Zuverlaessigkeits- und Leistungsueberwachung
    2. click Systemmonitor
    3. click the green "+" symbol
    4. select Battery Status / Discharge Rate
    5. unplug AC Power
    6. watch the power your M1330 draws off the battery

    If you want to measure the AC wattage, you have to buy one of these items:
    http://www.conrad.de/goto.php?artikel=124400
    http://www.conrad.de/goto.php?artikel=125319
    http://www.conrad.de/goto.php?artikel=125323

    I never heard/saw/can image of any mainboard that is able to measure the efficiency factor of its attached AC/DC power supply and the correct phase shift of the corresponding Ampere/Volt cosinus functions in AC power. Therefore I conclude:

    . the mainboard design of the M1330 is not bad
    . there is no performance loss whatsoever involved

    Maybe I did not understand your problem, but in this case I hope you provided a better description to technical support.

    regards,
    7oby
    Message Edited by 7oby on 03-13-2008 02:08 AM
  • 272

    0

    Posted March 13th, 2008 08:00

    The problem is somewhat more difficult. I don't need to know the power wattage. But my laptop does.

    When powering up the Computer isn't able to "determine the wattage of the ac adapter connected" and tells me this with a short message and two beeps. The text recommends to reseat the adapter and to always use original Dell hardware. As I have always been using the original Dell 65W adapter included I can't do it better :)

    The computer switches into the "unknown AC adapter mode" with reduced performance and doesn't reload the batteries. This is rather annoying as I am dependent on the batteries and paid for the 9 cell version. From time the computer is able to see that I am not lying to him and that there is the right adaptor installed. I then recharge my batteries. The laptop is only 4 months old and I don't think it should be already displaying this kind of trouble.
  • FrogLick

    10 Posts

    272

    0

    Posted March 13th, 2008 14:00

    Not clear if your problem is similar to mine reported in my posting ( AC Power turns OFF when battery low / XPS Laptops ) but it sounds like it's similar and reported by others as well.  Apparently there is a problem with the power management circuitry on the system board.  Dell eventually got it fixed by replacing the system board but it did take some time working with tech support before they sent out the repair tech for on site repair.  Keep after them and good luck.

  • 7oby

    193 Posts

    272

    0

    Posted March 14th, 2008 12:00

    Another indicator whether your AC power supply is recognized correctly might be the following:

     

    . Boot, press F2 and go to the BIOS

    . Section System / Devices

     

    And it tells you which type of power supply it found. In my case it mentions 65W AC Adapter.

     

    regards,

    7oby 

  • 272

    0

    Posted May 29th, 2008 18:00

    Hi,

     

    Actually I have exactly the same issue.

     

    XPS M1330 everything working fine.

     

    Then one day, it complains that it cant detect what type of power suppy i am using. It thinks I am using a 3rd party one.

     

    I am using the standard 65w supply that came with the machine.

     

    It doesnt charge the battery any more. It did work a couple of times, but it stopped shortly after. I have half battery left now, and it refuses to charge.

     

    Will be logging a case with Dell to see what they say.

     

    Cheers,

     

    Tim