UNSOLVED

pred1128

updated

20 years ago

Closed

P

pred1128

9 Posts

0

4180

November 25th, 2006 19:00

9100 Montherboard Issue/Question

I just replaced the motherboard in my Inspiron 9100.  After installing the cpu wouldn't boot.  I just received the LED flashing 9 times.  I took the memmory out of DIMM B and it starts fine but it is extremely slow.  Any ideas on what this could be?  Thanks.
  • fjabad

    10 Posts

    184

    0

    Posted November 25th, 2006 22:00

    What kind of motherboard is the replacement? The default setings on your new motherboard can be causing problems. But It's hard to tell without knowing your mobo.
  • pred1128

    9 Posts

    184

    0

    Posted November 25th, 2006 22:00

    Old Board is:  (A00) BDQ20 LA1711 Rev 2.0
     
    New Board is: (A01) BDQ20 LA1711 Rev 3.0
     
     
  • fjabad

    10 Posts

    184

    0

    Posted November 25th, 2006 23:00

    Your newer motherboard has a different version BIOS than your older one. I suspect that the default configuration is causing problems. I would suggest putting in your older motherboard, go into BIOS, write down all settings. Install your newer motherboard, go into BIOS and see if any discrepancies. If so, just change the settings to match your old ones. Also, because of the newer BIOS version, there may be additional settings. I would say, leave those to default settings. Hopefully this helps. Note the settings of your RAM and primary hard drive in particular. Hope this helps.
  • pred1128

    9 Posts

    184

    0

    Posted November 26th, 2006 07:00

    My old board is fried.  Won't boot up at all.  Any other ideas?  Thanks!