
UNSOLVED
U
UnLeashed187
3 Posts
0
5674
September 14th, 2004 02:00
URGENT PLEASE HELP
I bought a new case last weekend and currently have a dell desktop. I opened the case and started taking everything a part to transfer over. Like a dumb person I am I didn't read this site how to take apart the motherboard. I finally got the motherboard to slide out but there was a metal casing surrounding the motherboard. After giving up I decided to put the motherboard and everything back into the computer. So I finally got the computer up and running but then got a message saying .......mark this check point [Disk0] and contact a dell tech support in the start up menu. Then as I looked below that it said Something Like THERMAL something, and said previous attemps to reboot have not worked.......? I do not know what is wrong someone please help me I would appreciate it a lot for any info.... THANKS
-CHAD
Responses (2)
Solutions (0)
UnLeashed187
3 Posts
186
0
Posted September 14th, 2004 18:00
Thank You for your reply I appreciate it a lot. I do not have the specs and can't think of the model number, I'll get it when I get home. I was wondering though if you have heard of or anything close to this: [Disk0] check point, write this check point down and contact dell to assist you. Then after I reboot it the check point changes to [Oops] then it would change to a different check point. I was wondering if I connect the IDE cables wrong or something like that. But I shouldn't have since it's basically idiot proof to put everything back the way it was. If you have any ideas to what these CHECK POINTS are please let me know.
-Chad

joemomma
40 Posts
186
0
Posted September 14th, 2004 18:00
You've got a couple of issues going here....
1) You're aftermarket case is not going to work without some serious modification to wiring (front panel, control panel connections) due to the proprietary connections on your Dell system
2) Thermal events are triggered by something getting too hot- more than likely your CPU. Did you remove the thermal pad/grease from your CPU/heatsink? If you did, you're going to want to get that replaced (Artic Silver is great, just a very thin layer. You don't want that junk getting everywhere....) If you didn't remove it, you probably don't have your heatsink installed properly. Make sure it is seated to the CPU good.
More help can be provided if you'll provide us with specifics about your particular PC (Dell model #, etc.).