
UNSOLVED
Failed CPU Fan in 8400
Two nights ago as I was browsing the internet, a loud grinding noise coupled with a periodic impacting sound came from the case, lasting about 4 seconds, whereupon the computer shut itself off (!)
Next was a blinking yellow light inside the power button, and the computer would not respond at all to the power button. I opened up the case and didn't see any problems, so I began to think that perhaps the power supply had failed, and perhaps the grinding was the PSU fan death throes. I unplugged the power cord and reinstalled it, and the computer made a noise as if it would try to start up (fan noise, I'm not sure which) and immediately shut back off with corresponding ozone scent.
I called customer support to see what we could do. He suggested I try starting it again, and lo and behold, it started, but stuck at the bios with a fan failure error, suggesting F1 or F2, neither of which did anything. Sure enough, the CPU fan was only twitching rather than spinning.
So support is sending a new fan, along with another CPU heat exchanger (he said so that they could work together ?? where do they get these people?) and I meanwhile checked the voltages at the MB connector. I did not record the voltages, but they seemed normal enough; 4.7 11.8 and 0.0 V however, I am not sure which order (pin wise) those were and I don't have any schematic which tells me what expected values should be.
Has anybody had this problem? Does anybody know what are the proper voltage values for the CPU fan pins? Does this sound like the proper response (self shut down) to a failed CPU fan?
I would as always appreciate any input that the experts here have to offer.
Thanks,
Wes
8400
530 3.0 PIV
512 GB DDR2 @ 533mHz
x300se
Responses (1)
Solutions (0)

robinhood42
2 Intern
•
1154 Posts
50
0
Posted October 11th, 2004 03:00