UNSOLVED

Trafficflow

updated

16 years ago

T

Trafficflow

2 Intern

•

295 Posts

0

5962

May 27th, 2010 18:00

Dimension E5210 Boot up Issues

Hello everyone,

 I am working on a E5210 computers and I need some ideas. On start up I am getting the error message " Error Allocating Mem Bar  for PCI Device and floppy disk seek failure. The computer has no floppy drive. I took the cover off and blew the dust out as always and by the way the error was there before I took it apart. It has a video card installed and I reseated the memory. I looked in the setup and not see anywhere I could turn the floppy off. I thought about  doing a reset but  have not yet. Did run a hard drive diagnostic for the heck of it. I don't see a mem test. Any ideas?

Thanks  

  • Trafficflow

    2 Intern

    •

    295 Posts

    231

    0

    Posted May 28th, 2010 22:00

    Dimension Bootup

    Hello anybody had the same problem. I was hoping to get some ideas.  I took the nic crd out and the problem went away. I put it back in and in a different slot and same thing happens. The other issue, I went into bios startup and removed the order number whick takes to none i would think. Still the same issues.I will put the nic card back in the original slot and see what it does and hook up a cable and see what happens. Any other ideas anybody Please. This is a friends computer and I am trying to get it back to him but this is a new one for me.