
UNSOLVED
Dimension 8400 boot fails at checkpoint ITHR
Dimension 8400 Pentium 4 (3.2GHz) / 160GB Serial ATA HD / 2GB DDR2 SDRAM
My 6-yr old Dimension 8400 has been running perfectly since the day I bought it, but 2 days ago it just died and won't boot; I can't get past the Dell screen. I get the message:
Alert! Prevoius attempts at booting this system have failed at checkpoint ITHR.
The diagnostics lights are all Green. I found several threads in the forum on this same topic and have tried all the suggestions like removing /re-inserting system board battery, vacuuming entire inside, checking motherboard capacitators for leaking or bulging, re-seating all cards and checking all cable connections.
Still can't get past the Dell screen. Is there a particular "F" key I should hit when the Dell screen appears...I've tried F12, F2 and F8 but nothing happens. Is there any chance of retrieving data from the hard drive if the system won't boot?
I am looking for help on getting the system to boot into Windows just long enough for me to transfer the contents of the hard drive to another computer. Thanks for any and all suggestions. Joan
Responses (2)
Solutions (0)
A drive wire will allow transfer of the data
Disconnect the power from the wall
Press/hold power button for ~15 sec
Open case and remove battery
Press/hold power button again
Reinstall battery (right side up!)
Close case
Restart.APRICORN DriveWire IDE/PATA/SATA to USB Hard Drive Adapter ...

jackshack
6447 Posts
366
0
Posted May 15th, 2011 22:00
Judging from the info available in the forum and on the net there is no for sure solution to this problem other than replacing the computer. For some folks, disconnecting the power, removing the CMOS battery for a few minutes, coupled with pushing the power button and holding that in for about fifteen seconds, seems to clear the problem at least temporarily. For others, unplugging all USB connections while the computer boots and then plugging the keyboard, mouse, and whatever else you have, back into the tower works. One post even claimed that plugging a different monitor into the tower cleared up the problem. Then there is the post that claims the problem is related to temperature, but if that was your problem I would think the cleaning you gave it should help.
I was once convinced that this was a USB problem based on a note from Dell with regard to one of the Optiplex systems. The work around for that case was to stop using the rear USB ports during the period that the machine was in the boot process and plugging things back in when the boot was complete. Needless to say I no longer have that particular conviction.
You can try removing any expansion cards you have installed in the computer to see if it will boot with nothing but the monitor, keyboard, and mouse, but this is simply one more straw to grasp. I think the key to the "solutions" you see on a search is that you have changed the physical configuration of the computer and some failure indication gets cleared so that the computer boots.