UNSOLVED

MarkDownUnder

updated

20 years ago

0

4619

April 5th, 2007 20:00

4600 Won't Turn On - Not Power Supply?

My Dimension 4600 (just over 3 years old) had what I thought were textbook symptoms of the oh-so-common bad power supply. The tiny green LED on the motherboard lights up, but everything else is dead - the fans, the front LEDs, the ABCD lights on the back. Here's what I've tried so far: 1) Put in a new 400W PSU. It blew smoke as soon as I plugged it in. Everything was connected correctly. Hope the faulty PSU didn't make things worse. 2) Put in a new 450W PSU. No smoke this time, but computer is still dead. I tried jumpering the on switch pins just in case the switch is the problem. Still nothing. Green LED on the mobo is the only sign of life. 3) Disconnected all cables to the drives, removed RAM, all PCI and AGP cards. Still no response with both the original and new 450W PSUs. So now I'm starting to think the motherboard must be dead. Is there a way I can confirm this? Anything else I should try before buying a new motherboard? Thank you in advance for any help! Mark
  • srlatty

    8 Posts

    96

    0

    Posted April 5th, 2007 23:00

    My Dimension 8400 has exactly the same symptoms.  I just found it a couple days ago and haven't had much time to troubleshoot.  I did the same tests as you, without replacing the power supply.  I was sure the power supply was shot.  I opened it up and the fan was hard to turn and it looked like the pcb that the fan plugged into had gotten hot.   Like you said, any  otherideas before replacing the MB?
  • shesagordie

    12 Elder

    •

    46017 Posts

    96

    0

    Posted April 6th, 2007 02:00

    MarkDownUnder

    As the power supply checks out and the system still does not boot.

    Try removing all the PCI cards, the video card and memory, disconnect the data and power cables to all the drives, then check that the front panel cable is connected to motherboard, with nothing else connected to the system, except the power cable to the power supply, power the system on.

    If you do not get any beep codes or no LEDs on the back panel, then it would appear that motherboard has died.

    Bev.





    ===================================================
    Please don't send me questions about your system by DCF Messenger.
    Post the issue in the appropriate Board, where they will be answered.