
UNSOLVED
4400 on its way
hi All,
I'm supposed to get my 4400 today according to tracking. The issue I'm faced with now is transferring data and files from my old PC to this one. My old PC is very old, a P-150, over 7 yrs old. No USB. Also I'll continue to use my old monitor, so will not be able to have the two systems running at the same time. So I think the best thing would be to yank the hard drive out of it and put it in the 4400.
Is this easy to do? What does it mean to have a hard drive as a slave? Will there be anything in the manuals with my new 4400 explaining how to install a second drive? How do I do it?
thanx for any input,
- Z
Message Edited on 04/24/02 11:59AM by zvarro
I'm supposed to get my 4400 today according to tracking. The issue I'm faced with now is transferring data and files from my old PC to this one. My old PC is very old, a P-150, over 7 yrs old. No USB. Also I'll continue to use my old monitor, so will not be able to have the two systems running at the same time. So I think the best thing would be to yank the hard drive out of it and put it in the 4400.
Is this easy to do? What does it mean to have a hard drive as a slave? Will there be anything in the manuals with my new 4400 explaining how to install a second drive? How do I do it?
thanx for any input,
- Z
Message Edited on 04/24/02 11:59AM by zvarro
Responses (4)
Solutions (0)
- A drive that old might not even work in your new Dimension 4400. Today's computers use Ultra ATA 100 IDE. This is "supposedly" backwards compatible with ATA 66 or ATA 33 but I've heard horror stories. How much data are we talking about? Hard drives weren't that big back then.
Some other suggestions:
2 NIC's and a crossover cable or network HUB
Direct Cable Connection via parallel or serial ports (DCC cable cost about $20)
Buy a big box of floppies and use WinZip to compress and span the data
- hi,
thanx for the reply. Actually, even though my PC is over 7 yrs old, the hard drive in it crashed in 1999, and I replaced it then. So the HD is a 4.3 gig FAT 32, installed in 1999. The amount of data is not huge, but quite a bit, lots of personal files, millions of contacts in Outlook, bookmarks, etc etc.
Can I connect the 2 PCs and transfer files if I only have one monitor?
So do you think it'll be possible to put this 4.3 gig HD into my 4400. What horror stories have you heard? Can I do serious damage to my 4400?
- Z
- No if the hard drive has already been replaced in 1999, that proves it is not proprietary or outdated equipment. It should work without a hitch. Just set the jumper on the back to slave. I wouldn't leave it in permanently, because it could slow down the IDE chain. You are only as fast as you slowest link. Sorry to scare you. Since you don't have a NIC or CDRW drive in the old computer this is your best bet.
W.

masterdlx
4 Posts
188
0
Posted April 24th, 2002 16:00
Sincerely,
Dylan