In case you are interested in zoning from the CLI here are the tasks:
Run the following comand to find out what your active zoneset name is. Make a note of this zoneset since you will need it later
show zoneset active
Create aliases
conf t
fcalias name vsan
member pwwn
To get the wwpn's of the HBAs that are logged in to the switch run: show flogi database
exit
Create additional aliases using the same commands
Create a zone and add two members to the zone (EMC best practice is to create single-initiator, single-target zoning)
zone name vsan
member fcalias
member fcalias
exit
Create additional zones using the same commands
Add the zones into the active zoneset
zoneset name vsan
member
Continue adding your zone name using the member command. Once you are done adding the zones don't forget to type exit
Activate the zoneset
zoneset activate name vsan
You might have to enter the zone commit command but that depends on the NX-OS the Cisco switches are running. It doesn't hurt running the command just to be certain. If the command fails then you can safely ignore it
healyj
141 Posts
1401
0
Posted December 12th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we will set it to “answered.”
Regards,
Jim