CX3 series have SNMP support inbuilt. however, you must note that you cannot manage or control the array using SNMP. you can just read the interface counters (stats related to FA ports)
you can only query the array for fibre channel related SNMP tree and also setup your SNMP infrastructure so that the array can send a trap to the station in case of alert.
for this you need to enable SNMP agent on the array and setup alerting accordingly.
you can refer a good whitepaper "manageing emc clariion with snmp" on powerlink about enabling and setting up SNMP..
note that the MIBs mentioned in the documents are not EMC specific. your SNMP software should have them inbuilt or you can download them from internet. the required MIBs are Fibre alliance MIB and snmpv2 MIBs (not sure of second one but FA MIB is for sure)
wescott1
36 Posts
226
0
Posted May 19th, 2008 11:00
The mib describing traps sent by the array can be found in the knowledgebase article emc171987.