UNSOLVED

djl4468

updated

12 years ago

D

djl4468

9 Posts

1

2602

July 21st, 2014 17:00

Centera Viewer 4.3: problem when running scripts

Hi Everyone!

As part of a field install of a Centera, I have downloaded and installed Global Services 4.3 on my Windows 7 64-bit laptop.

I have logged into the Centera and am attempting to run the "show cluster time" script. However, I am getting a "result not ok" error.

Can anyone shed light on what this means.  BTW, I also tried running "adjust cluster time"...same error, "result not ok." If anyone can assist on this (preferably before I go onsite tomorrow morning 7/22), please PM me at djl@icgcan.com.  Thanks!

P.S: No roles have been defined on the nodes as yet and I am communicating through the cube switch.

  • 956

    0

    Posted July 22nd, 2014 00:00

    Please try  it again after completing the installation. There is no need for the customer to connect to the cube switch and CV should logon to a node (IP adress) with management role.

  • djl4468

    9 Posts

    955

    0

    Posted July 22nd, 2014 02:00

    Hi Helmut!

    Thanks for your response!

    The Solve Desktop produced a procedure that directs you to check/adjust the cluster time *before* roles have been defined, hence why we are accessing the nodes via port 24 on the cube switch.  We are waiting for our LAN ports to become active. Once the LAN ports are live, we will configure external roles and try again.

    Best regards,

    Derek

    djl@icgcan.com

  • 955

    0

    Posted November 26th, 2014 03:00

    Hi Mohammed,

    Please confirm, that you exactly followed ALL steps described in Chapter  "Installation Set Cluster Time" in the document for new installs, compiled by the Procedure Generator. e.g. Nodes unlocked;  your PC time is less than 5 minutes away from  e.g. www.thetimenow.com

  • omarelmazny

    19 Posts

    955

    0

    Posted December 1st, 2014 00:00

    Hi Derek,

    you need to use the latest serviceext.jar, you can ask Centera support to give that to you.