While reassembling my AW17 R3 I did damage my Wifi card pins and their antenna cables. It was a chance to upgrade the old card with a new one (Intel AX200). Now I am facing many choices to replace the old damaged antenna cables but I do not know if they are all ok to go with:
1- Buying any new antenna cable from amazon (Assuming it is just standard for any laptop)
2- Buying used AW17 R3 cable (Assuming it is specific for AW17 R3)
3- Buying any AW antenna cable (Assuming they are specific for AW laptops in general)
4- Trying to replace the damaged coaxial terminals of the cables with new coaxial terminals
What is the best solution? and is there a choices should I avoid?
Since you will need to remove the existing cables anyway, measure them and then order accordingly. That said, the chances of damaging something when you disassemble the display assembly are high enough, if you don't want to solder a new lead on the antenna, you may be better off simply purchasing a USB wifi adapter.
You're going to be dismantling an assembly with plastic that is 10 years old -- the chances you'll damage something are not insignificant.
Hi @Simzware welcome to this free user to user Alienware laptop discussion forum.
Thank you for including photographs in the opening post. The main white Wi-Fi connector has been detached from its card, but the main white antenna termination photograph is not in focus. Please have a good look at wire termination to determine if detached connector continues to be held within wire claw. If yes, carefully remove detached connector and install new Wi-Fi card.
[This user does not work for Dell and volunteers their free time. Please remember to say thank you by clicking on my thumb up icon.]
Hi@crimsom, Thanks for your reply and help. I have tried many times to connect the white cable to the Wi-Fi card but it was no use. On the other hand, the black cable could smoothly be connected many times. The condition of the white cable is not good comparing to the black cable. Here are some photos of the cables:
Unfortunately and as I expected, the white cable is now totally damaged. I went today to a workshop and they told me it is not possible to get its termination replaced. They also told me that the only solution is to replace the whole cable, which is not a big deal for me. I have no problem to do it myself and this leads us to the first three choices top in the main post. Thanks for your time and your help.
Replacing the complete Alienware 17 R3 Wi-Fi antenna cable has the potential to damage many other laptop parts. Can the now detached ipx connector be reattached? Alternatively get another ipx connector with the antenna cable attached and splice the wires, solder and heat shrink. It may seem an internal to laptop amateur fix, but it would probably be easier and safer than replacing the whole antenna cable and pulling the lid and screen panel apart.
I have replaced a complete laptop Wi-Fi antenna cable but pulling the lid apart can detach/break many of the plastic lugs that hold this assembly together at the rim. Installing a new complete lid and screen assembly is the professional but expensive solution.
[This user does not work for Dell and volunteers their free time. Please remember to say thank you by clicking on my thumb up icon.]
It is not possible to solder the cable. And actually, I do not have a problem with replacing the cable. All what I need to know is the type and the length of the antenna cable of Alienware 17 R3.
ejn63
12 Elder
•
31843 Posts
•
156259 Points
2259
1
Posted September 17th, 2022 10:00
Since you will need to remove the existing cables anyway, measure them and then order accordingly. That said, the chances of damaging something when you disassemble the display assembly are high enough, if you don't want to solder a new lead on the antenna, you may be better off simply purchasing a USB wifi adapter.
You're going to be dismantling an assembly with plastic that is 10 years old -- the chances you'll damage something are not insignificant.