
UNSOLVED
Closed
XPS 13 9370 couple of queries ...
Just set up my new XPS 13 9370 today but have a few niggles:
1. Screen alignment - the top left & right corners are much lower than the rest of the screen in relation to the bezel & there are a few places on the edge of the screen, mainly at the top where you can press it down ie as if it's not stuck down all the way round. I'd accept this on a £300 laptop but for a premium product like the XPS surely this is not how it should be?
2. the power test button on the left hand side seems to need pressing quite hard before the indicator lights come on as if it's recessed too far or should it be like this?
3.Fingerprint scanner seems a bit hit and miss?
Wondered what other folks experiences of the above have been?
On the upside you can now easily turn off the DBC in BIOS with the FHD screen :)
This conversation is no longer open for comments or replies and is no longer visible to community members.
Responses (3)
Solutions (0)
@dotdose wrote:
Same issue as your #1 (left side doesn't sit as flush as right on top leading edge when closed).
Additionally, I have a very noticeable gap on the rights side where screen hinge meets the body. @LJC1 can you see how your hinge spacing is on both left and right side? Are they comparable?
Thanks.
Hi,
Not sure if I explained myself that well; my problem is that the surface of the screen dips down in the top corners ie sit about 3mm below the bezel whereas around the rest of the screen it's more like 1mm. This is only noticeable when the laptop is open. When closed however, all appears to be pretty flush and even.
Thought my hinge spacing was fine - looks even form the top - but then viewed your photos on another thread & yes mine looks exactly the same from that angle. However I'm not really too concerned about that aspect...
As well as the battery check button needing to be pressed down rather hard, I even find the power button to turn machine on to be a little spongy, not very precise but maybe that's just how they all are.
seems maybe we have slightly different problems but nevertheless I don't think acceptable for such an expensive flagship machine, maybe acceptable on a £300 laptop. I'll see what Dell say tomorrow - may ask for a replacement although of course they may consider it 'within tolerances' & there's always the chance of getting a replacement that's worse...

dotdose
3 Posts
1180
0
Posted February 10th, 2018 18:00
Same issue as your #1 (left side doesn't sit as flush as right on top leading edge when closed).
Additionally, I have a very noticeable gap on the rights side where screen hinge meets the body. @LJC1 can you see how your hinge spacing is on both left and right side? Are they comparable?
Thanks.