UNSOLVED

Mark17

updated

23 years ago

M

Mark17

4 Posts

0

4137

October 16th, 2003 18:00

Starting up windows XP home

Hello,

when you start up you're dell dimension with winXP home or pro you first get the dimension serie message then the XP loading, then a short black screen and then the welkom screen of winXP. So far, so good. But when I start up my computer the black screen between the xp loading and the welkom screen stay's on for a long time. A very long time; +/- 1 1/2 min. So I thought, oh Lord, again useles stuff in msconfig >start up. But there wasn't. There is also no virus on my pc so here I am. Can someone help me solve this problem. We are talking over WinXP Home edition.

Regards,
Mark

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    565

    0

    Posted October 16th, 2003 18:00

    Mark17,

    Welcome to the Dell Community Forum (DCF).
    What USB devices are connected to this system?


    DELL-Chris M (old account)

    #IWork4Dell

  • Mark17

    4 Posts

    565

    0

    Posted October 17th, 2003 15:00

    There is a usb 2.0 card reader from lead data connected. It read's compact flash cards and memorystick.
  • bobst2003

    6 Posts

    565

    0

    Posted November 8th, 2003 20:00

    I have the same problem, only its blank screen for over 7 minutes.... I have a fine pix camera cord connected....
  • Mark17

    4 Posts

    565

    0

    Posted November 9th, 2003 08:00

    It was the usb device that couse the problem. I also have a alcatel speedtouch usb modem connected. This one starts loading when XP is loaded. The Card-reader is checking in during the start up. This couses the black screen. So now I've disconnected the device and XP starts up fast like always. When I have to use the reader. I'll connect it to the soccet and voila, it works fine to me. Very fast, just like usb 2.0 has to be. You should try it.

    Regards

  • thanhvn

    75 Posts

    565

    0

    Posted November 12th, 2003 03:00

    a bad hd (or corrupted MFT on it) can also causes the problem
  • dogin

    392 Posts

    565

    0

    Posted December 16th, 2003 17:00

    If you are not on a home network (with other computers), go to start-run-msconfig-services and uncheck workstation (you can always check again) restart computer and post back with results. leave the USB devices attached for this test to see if it helps????

    Message Edited by dogin on 12-16-2003 01:05 PM

  • Mark17

    4 Posts

    565

    0

    Posted December 16th, 2003 19:00

    Hi,

    thanks for you're additional help. I tried it but it didn't work. Tried it again with the device disconnected and it runs a fast and clean start up again. That works for me. Thanks for the help! It would be great to leave the device attached so every idea is welcome.

    Mark

  • dogin

    392 Posts

    565

    0

    Posted December 17th, 2003 00:00

    Sorry it did not work, but thanks for trying it. I have a different system and different USB devices (a five connector USB port built into  my monitor is also connected that is completelly filled with connected devices, plus my DVD recorder plugged into the USB 2.0 USB card. Was not sure if unchecking the workstation on mine eliminated my slow down or not, but it booted normal again on my next boot. Was hoping it would for you!