UNSOLVED

gregar60

updated

20 years ago

G

gregar60

16 Posts

0

9537

June 20th, 2006 11:00

Reinstall Windows

Dimension 8300 Oct 03
P4 2.8 Ghz
1 GB ram
PNY Geforce 6600 256
Audigy sound blaster 4
CD RW
DVD RW
40 GB WD HD (came with computer)
160 GB WD
450 w power supply
 
I decided to replace 40 gb with 160, I changed the cable settings, both on cable select, had many problems with install.  I made a 100 GB and a 60 GB partition

Fist tried to install copy of XP PRO, was not recognizing boot sector at first, then finally loaded, but subsequent loads did not recognize boot sector.

I reloaded recovery disk that came with dell and all loaded fine.
 
It now takes about five minutes for the window's screen to load and there are only a few programs on my new install...  Firefox and AVG..
 
I guess my question in all of this is, when i want to install windows fresh on a dell computer, is there anything special I need to do, or can I just install the cd..

It actually seems a simple process, but not sure if I need to do any other step..

Any ideas...
  • 205

    0

    Posted June 20th, 2006 19:00

    As long as your drive partitions are setup properly and you can get to a command prompt easily with a boot disk, then their shouldn't be an issue with getting Windows installed. Just boot off the Windows cd and walk through the menu. I recommend the standard NTFS format over the quick format.
  • gregar60

    16 Posts

    205

    0

    Posted June 21st, 2006 09:00

    partitioned 40 and 120 gb, formatting the 40 full.

    started at 8pm EST and it is now 630 am EST and only at 86 percent

    i have cable select on the drive and have it at the end connector on the ribbon.

    i now remenber a few months back i tryed to defrag the 160 when it was only for storage, and it ran all night and only was 25% done
  • Denny Denham

    2 Intern

    •

    18798 Posts

    205

    0

    Posted June 21st, 2006 15:00

    gregar60,

    See if this applies to your system.

  • gregar60

    16 Posts

    205

    0

    Posted June 22nd, 2006 13:00

    thanks for the reply, i was on normal mode.

    I reran the full format last night and will be finished tonight, 24 hours to reformat a 40 gb partision

    and I will try to  rerun the install

  • 205

    0

    Posted June 27th, 2006 01:00

    Gegor, your Hard Drive is reading wayyyy too slow. If you are still working on this problem. (I realize you posted almost a week ago) then try a different IDE cable, try changing the drives from Cable Select to Master / Slave with slave set on the center connection. The bios should be set to auto detect the drives and have no problem identifying them. If still going slow, then there's probably an issue with the IDE controller or something else on the motherboard.
  • gregar60

    16 Posts

    205

    0

    Posted June 28th, 2006 01:00

    thanks

    tired a new hd and it worked fine.

    thanks