UNSOLVED

SalKhan

updated

16 years ago

S

SalKhan

12 Posts

0

5130

January 12th, 2011 20:00

Datamover Failover

If all ethernet ports fail on a Data mover will it do a failover beacuse failure of ports will be a hardware fault .

Also can we customize the failover as to when and under which conditions we want a failoverr to happen ?

  • Storagesavvy

    474 Posts

    681

    1

    Posted January 12th, 2011 20:00

    If the physical port hardware inside the datamover fails, it is unlikely to trigger a datamover failover.  Redirection of FailSafeNetwork is less disruptive to users compared to a datamover failover.

  • SalKhan

    12 Posts

    681

    0

    Posted January 12th, 2011 20:00

    thnx for all the answers guys ,

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    681

    0

    Posted January 12th, 2011 20:00

    link failure will not cause datamovers to failover.

  • SalKhan

    12 Posts

    681

    0

    Posted January 12th, 2011 20:00

    I am aware that link failure will cause datamover failover but will the physical port also will not cause link failure ?

  • Storagesavvy

    474 Posts

    681

    0

    Posted January 12th, 2011 20:00

    Datamover failover is NOT triggered by the loss of all ethernet ports.  If you want switch redundancy, you can use the FailSafeNetwork feature and connect each leg of the FSN to a different switch.  If you have newer network equipment that can support etherchannel or LACP trunks across multiple switches, that can also be used to provide network redundancy.

    A datamover failover occurs as a result of a datamover panic which can be caused by hardware failures, loss of backend storage, and other similar events.

    The only datamover failover settings to my knowledge adjust whether failover occurs automatically or waits for administrator, and there is an option to attempt a datamover reboot before failing over as well.

  • Rainer_EMC

    6 Operator

    •

    8645 Posts

    681

    0

    Posted January 13th, 2011 00:00

    the software won't detect physical link/card failure unless it causes a panic - so no

  • Rainer_EMC

    6 Operator

    •

    8645 Posts

    681

    0

    Posted January 13th, 2011 00:00

    correct