Use symcli 8.4. If use prior then a parameter called vol geometry will be set and you need to call support each time you want to extend a vol to reset it.
You may want to open an SR for a proper investigation. But something else to check is if the GCM flag is set on the dev you are trying to expand. You should be able to see it with the "symdev show" command. If GCM is set then the OS may not recognize the new size.
I'm not sure which exact step the flag is set. Honestly don't have much experience with NDM, asked around after seeing your post and was told that GCM could be affecting it. The info below is from Page 74 in the linked document states. So you may be best to open the SR for assistance.
During NDM, “user defined” geometry is set on all devices within the SG. To allow the expansion of target devices post migration we will require the geometry to be set to “Native”. This will require Solutions Enabler 8.4 and is user configurable at this level.
In the case where the device being migrated was an odd cylinder count the GCM flag will also be set. This flag is not currently user configurable. Expansion of such devices will require the LUN to be taken offline and adjusted by contacting Dell EMC support. This is to be rectified in the next Hypermax OS release and will be user adjustable as long as the LUN is not in a replication session.
Just had the same issue. NDM sets the GCM Flag on some devices. You can check this with "symdev show". In this output you have an entry "Geometry". This could have 3 values:
native - no GCM Flag ist set
user defined - usually set by NDM
Geometry Compatibility Mode - set by SRDF/NDM when cylinders are odd
If the Geometry Flag is "user defined", you can remove the flag with no issues, use command (needs solution enabler 8.4): "symdev -sid xxx set -geometry LUNID -default". After Hostrescan the new size is visible
If the Geometry Flag is "Geometry Compatibility Mode", then you have to unmap the device before unset the Flag, only EMC Support can remove this flag. In future HypermaxOS release this can be done by symcli.
SKT2
2 Intern
•
1340 Posts
2620
0
Posted May 25th, 2017 22:00
We are also going with NDM shortly? Did you get feedback from support yet?