I`m looking into configuring remotely Active Directory with standard schema on our servers (generally iDRAC 7 and 8), but not entirely sure where to begin. I`ve successfully used this script in the past for various configuration changes, however I don`t know how to configure the role groups via racadm.
I`ve been playing around a bit and only found the following paramenters:
You can use below command to configure Active Directory role groups in iDRAC
racadm getconfig -g cfgStandardSchema -i 1
You can run below command to get help
racadm help cfgStandardSchema
There are 5 index for this command each index represent each role group in iDRAC
Note : getconfig and config are deprecated commands. These commands will work with current iDRAC firmware/ If you have latest iDRAC firmware installed on the server, then you can use below new commands(get and set) to configure iDRAC Active directory
I`m configuring the iDRACs with the following commands (ensured DNS and NTP configured properly before):
racadm set idrac.ActiveDirectory.Enable 1 racadm set idrac.ActiveDirectory.DCLookupDomainName our.domain racadm set idrac.ActiveDirectory.DomainController1 dc1.our.domain racadm set idrac.ActiveDirectory.DomainController2 dc2.our.domain racadm set idrac.ActiveDirectory.GlobalCatalog1 gc1.our.domain racadm set idrac.ActiveDirectory.GlobalCatalog2 gc2.our.domain racadm set idrac.ActiveDirectory.Schema 2 racadm set idrac.ADgroup.1.Domain our.domain racadm set idrac.ADgroup.1.Name OUR_GROUP racadm set idrac.ADgroup.1.Privilege 0x1ff
So far so good, I can log on to the iDRACs with my_user@our.domain, but I didn`t find the command to set the User Domain Name, therefore the our.domain isn`t available in the drop down list of domains at the login screen.
DELL-Shine K
6 Operator
•
3042 Posts
4185
0
Posted December 1st, 2015 20:00
You can use below command to configure Active Directory role groups in iDRAC
racadm getconfig -g cfgStandardSchema -i 1
You can run below command to get help
racadm help cfgStandardSchema
There are 5 index for this command each index represent each role group in iDRAC
Note : getconfig and config are deprecated commands. These commands will work with current iDRAC firmware/ If you have latest iDRAC firmware installed on the server, then you can use below new commands(get and set) to configure iDRAC Active directory
racadm get idrac.ActiveDirectory
racadm get idrac.ADGroup.1
racadm set idrac.ActiveDirectory.Enable Enabled
racadm set idrac.ADGroup.1.Domain testDomain.com
racadm help idrac.activeDirectory
racadm help idrac.ADGroup