symmaskdb -sid 000187431365 list database , I am getting the following output(part of the output)
Database Type : Type4
Last updated at : 10:06:46 AM on Mon Feb 19,2007
Director Identification : FA-3A
Director Port : 0
User-generated
Identifier Type Node Name Port Name Devices
---------------- ----- --------------------------------- ---------
50060b00001da656 Fibre
da1222 c0s3p2 00C3
00CB
00D3
00DB
........
........
If i execute symcfg -sid 000187431365 list -connections -capacity . The follwing is the output
Host Symmetrix Capacity (GB)
------------ -------------------------- -----------------------------------
Node Name ID Director Port Mapped STDs Mapped BCVs Paired BCVs
------------ ------------ -------- ---- ----------- ----------- -----------
My doubt is , I am not seeing da1222 host name while executing symcfg -sid 000187431365 list -connections -capacity. da1222 Host has some lun allocated to that(i.e you see it on the symmaskdb list database output). It is missing in symcfg -sid 000187431365 list -connections -capacity command.
Sometime the "symcfg -connections" command is believed to be the cure for every pain .. but as you wrote, it will report ONLY the hosts with installed an application that uses symapi (Solution Enabler in 99% of cases )
We have to assume that some of the hosts Naren is managing don't have S.E. installed but can see some device in the box (as the symmaskdb command told us)
Hi, The symmaskdb command does show contents of device masking database (VCMDB). The symcfg -connections list does show all the hosts that are connected to symmetrix and has SYMAPI software installed.
you can either load SE on each host or first you name your WWN in VCMDB database ..and then use "symmaskdb list capacity -host OracleBox -sid XXX" command.
I just need a CLI which will tell me the capacity allocated to particular host which doesn't have S.E installed.
Only solution which i am seeing now is to do symmaskdb list database where i can get all the symdevices allocated to the hosts connected to and get the corresponding capacities of that symdevice to calculate how much capacity allocated to the host which doesn't have SE.
Thank you very much for your reply. From your response i can understand that the host which doesn't have S.E installed will not be seen by symcfg -list -connections -capacity.
So can you please tell is there is any CLI which tells how much capacity allocated to the host which doesn't have S.E installed.
Naren .. I simply translated what someone else wrote before me ... I think you have to thanks also someone else
Just to summarize .. the only way I know of knowing how much disk is allocated to an host is to use symmaskdb and symdev to get the list and the size of the volumes assigned to a given WWN .. You can also rename the wwn as Dynamox said .. both are valid choices
I know it's not a command line .. but ECC gives you exactly what you are asking for
xe2sdc
6 Operator
•
2831 Posts
433
0
Posted September 18th, 2007 00:00
We have to assume that some of the hosts Naren is managing don't have S.E. installed but can see some device in the box (as the symmaskdb command told us)
-s-