UNSOLVED

blue jinn

updated

5 years ago

BJ

blue jinn

1 Rookie

•

1 Message

0

19136

December 21st, 2020 12:00

SupportAssist OS Recovery -factory reset greyed out, but can't find network card

Hello,

Inspiron 5566. Hard drive failed. So need to replace drive and obviously reinstall the OS.

Downloaded "Dell OS Recovery Tool" and prepared a USB drive per instructions. Laptop boots fine from the USB drive and loads the "SupportAssist"

However: The option for "reset to factory setting" i.e. reinstall windows 10) is "greyed out" the "recommended" option with updated drivers yadayadayada "Requires internet connection" and requires you to click on an option to configure network. However, the software then says it  won't find the network card. Went into BIOS and it's all enabled in BIOS. But the SupportAssist can't find a network interface. 

Why isn't the option to simply factory reset enabled, and is there a way to just force it? Otherwise, this complicated Dell OS Recovery Tool, is completely useless. 

  • portalsam

    3 Posts

    14746

    1

    Posted January 29th, 2021 16:00

    I had the same issue. What I had to do was in the Dell OS Recovery Tool switch to advanced mode. It then gave me the option of downloading an image that allows for manual factory resetting and one that does not allow for manual factory resetting. When using the OS Recovery Tool in automatic mode, it downloads the latter. For some reason I could not find this major difference mentioned on any of the documentation about the software and had to find it myself.

    In any case, I then went into disk management in Windows and deleted the existing partitions on the USB drive and created a fresh new simple volume (not doing this will cause the new image download to not work). Then I went into advanced mode and downloaded the image that allows for manual factory resetting. Next, I restarted the computer and went into the boot menu with F12. I chose the USB drive, and got a little worried that it wouldn't work again when horizontal white lines appeared on the screen, but after about 2 minutes the Windows setup started and I was able to reinstall Windows. Hope this helps.

  • 14148

    0

    Posted April 2nd, 2021 05:00

    Hi, what did you do with partitions while installing ? Did you delete them all even the system ones? I have 6 partitions. Some are primary Some are OS or system And some are recovery I don't know what to do with them
  • portalsam

    3 Posts

    10523

    0

    Posted October 20th, 2021 10:00

    I backed up any data I wanted to keep then deleted all partitions.

  • portalsam

    3 Posts

    10523

    0

    Posted October 20th, 2021 10:00

    I'm pretty sure there was a button to activate advanced mode, but I'm not 100% on that since it was last year and I don't fully remember. I don't have that computer with me anymore so I can't really check, sorry

  • 10529

    0

    Posted October 20th, 2021 10:00

    @portalsam how do you access the advanced mode in the Dell OS Recovery Tool. I can't seem to find the option anywhere in the GUI.

    Thanks!

  • 10519

    0

    Posted October 20th, 2021 13:00

    @portalsam  thanks anyway!

    I was looking for it in the Advanced Mode option in the GUI of the recovery boot disk,  that's where I went wrong. There is an Advanced Mode option in the Dell OS Recovery Tool that is used to build the boot disk.