Unable to power on the host because an SL cable is connected to an unpowered
device
Hey everyone,
I have a PowerEdge R750xa which was running fine until recently. After briefly opening the chassis yesterday to simply check for the GPUs, it won't boot up anymore.
All internal devices appear to be connected correctly. When plugging in the power supply, the front panel indicates "Initializing...", then just briefly shows the message "Chassis is open" and finally only shows "Unable to power on the host because an SL cable is connected to an unpowered device".
I interpret this message as some device is connected through data cables but not to any power supply. However, upon multiple inspection I cannot find anything like this...
Can anyone help me out with this and push me in the right direction?
thank you very much for your help. I think the controller and respective blue screws are meant to be at the front side of the machine. I saw a depiction of it on the GPU-riser removal instructions. However, that is not installed in my machine at all.
I then carefully lifted the fan array and found two connetors of the left GPU indeed disconnected from the board. Obviously, this is rather embarassing on my side. But I am just happy to have it up running again.
We just had this happen with and MX750c blade/sled. The remotely connected users were doing updates and rebooted the blade/sled, which was running VMWare esxi 7 and it would come online with power, and same error message. Literally nobody touches this system, but I checked all the power connections, which were good, so I just detached the blade for a couple of minutes, then reconnected it and powered it on. Took about 5 minutes or so, but it came back online. I'm checking that blade's logs to see if anything shows up.
DELL-Charles R
Moderator
•
4730 Posts
•
25476 Points
2693
1
Posted October 25th, 2022 06:00
Hello nickel3,
We have seen this if the controller card is totally or partially disconnected from the backplane.
Shut down, remove power.
Loosen the blue screws for the front controller, reseat the controller and tighten the blue screws.
Reseat SL (slimline) cables, and cables to backplane on both ends.
Dell EMC PowerEdge R750xa Installation and Service Manual
https://dell.to/3TS1LhZ
(edited)
DELL-Charles R
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Accept as Solution’. ‘Thumbs up’ the posts you like!