Electricity went out at our house while printer was on. Now printer won't boot all the way up. Goes thru paces and then stops before status bar on printer is complete.
Have unplugged brick and power cords, waited minutes and plugged back in, but still boot process stops before completing.
Is something on the hardware inside fried, or any other suggestions?? Help, PLEASE!!!
The only way I know of resetting the printer is to unplug the printer from the wall and also remove the power brick for 60 seconds. This resets any error messages the printer is getting.
Thanks Rick. Saw that suggestion in this forum, tried it and it doesn't help. Tried it multiple times. Printer was plugged into a surge protector, but Dell phone support yesterday hinted it was probably something hardware-related. Of course, they want a fee to diagnose, parts, labor, etc.
Anyone else have any other ideas? I'm thinking of checking into what new printers cost during the holiday sales vs. fee for diagnose, parts and labor to install parts. I have a techie son, if anyone else has a suggestion more detailed ... he might be able to manage a more involved suggestion. Thanks!!
Tried with and without surge protector. Tried it in different wall socket. Tried with USB cable instead of wireless. The brick does have a green light which is on when I insert the brick into the back of printer.
Still runs thru paces and stops at point where status bar is full.
I even smacked it good with my hand for good measure when it booted up and stopped. LOL
It doesn't come on enough to copy a document under the glass?
Peek inside and see if you can see anything like a red light? Some of the older models had a red light come on inside. Not sure what to do if you see it.
Not sure if you can get to the menu part of the printer.
From the printer control panel, navigate to:
> Settings > > Settings > > General Settings > > Factory Defaults > > Restore Now >
I suspect the power surge has passed the surge protector and went through the printer, not sure how unless the power spike was a huge spike.
Menu never appears in front window display, so can't do any copy/fax/scan/print/printer control panel. Front window display has status bar stuck in it. No red light inside. I've pressed a million different combinations of buttons on front panel, but no luck.
PudgyOne
11 Legend
•
30315 Posts
•
106638 Points
1613
0
Posted November 20th, 2015 02:00
kag1949,
The only way I know of resetting the printer is to unplug the printer from the wall and also remove the power brick for 60 seconds. This resets any error messages the printer is getting.
Rick