Most likely the fuser is bad..... but pretty rare for a 2 yr. old printer.
However, it could be a main board or SMPS causing this. The fuser temp is monitored by a device on the fuser and the signal is sent to the main board. The main board determines if the temp is too high, too low, or correct. It sends signals to the SMPS to turn the heat lamp off/on to regulate the temp. In other words.... a closed loop.
The fuser is the easiest and cheapest thing to try first.
jlamyx
1 Message
319
0
Posted April 7th, 2009 15:00
Did you ever find out what this error message meant?