I have been dealing with an issue of my printer going into a status off mode and it will not come out of it without restarting my computer. I have tried a firmware upgrade but that took almost 6 hours to complete and nothing happened. Dell's tech support is useless as they don't have a clue. Is anyone else experiencing this?
My issue is that our 3100cn displays ready to print but print jobs sent to the printer never print! You have to power the printer off and then power it back on - then it will print.
I've tried updating the firmware, the drivers, reinstalled the printer (we have four PCs and this occurs on all installs) numerous times.
Also chalk up another tally for zero Dell response on the problem.
I've been searching the Dell boards for about 45 minutes using every search option I could squeeze out before stopping and posting here as my patience level drops to dangerous levels (I'm starting to have hallucinations of a sledge hammer sitting next to my Dell printer). I found and read at least 6 posts directly relating to some sort of power suspend/wakeup issue in which the printer simply does not respond when print jobs are submitted to it, and is usually fixed by a PC and/or printer power cycle. Yet NONE of the posts has a response containing any sort of solution.
After reading the posts and dealing with the same issue myself on a Dell 3010cn Color Laser connected through USB to a Dell Dimension 5150 running XP is that the root of the issue lies somewhere in power suspendsville. My initial analysis of the issue pointed toward either a PC power suspend/wakeup issue due to the USB connection. However, it appears there are a fair number of problems like this using ethernet.
In my specific case, the printer works fine until the PC enters a power suspend state. Once this occurs, the printer will not usually respond to print job submissions after the PC is brought out of suspend. I wrote "usually" as there have been times when it has not had this issue after a suspend wakeup. Another reason my initial hypothesis pointed to a potential USB connectivity issue. The problem is fixed by power cycling the printer. It may also be of importance to note the printer display panel never shows anything but "ready".
One can only hope the silence with respect to an answer on this issue is due to the large numbers of Dell technicians scurrying about the lab in their white coats and goggles as they work overtime in an attempt to address the problem.
I've had exactly the same problem with my 3010cn. After my PC has resumed from suspend mode the printer won't respond to any printer jobs. Never had this problem with my EPSON laser. Beginning to wish I'd never tried out DELL.
My Dell 3100cn displays ready\stand by to print but print jobs sent to the printer never print! You have to power the printer off and then power it back on - then it will print. It is connected the a print server. Any ideas?
lcanania
1 Message
225
0
Posted November 1st, 2006 02:00
I've tried updating the firmware, the drivers, reinstalled the printer (we have four PCs and this occurs on all installs) numerous times.
I'm wondering if this isn't somehow related.
Lance