UNSOLVED

SteveP55419

updated

19 years ago

S

SteveP55419

106 Posts

0

5917

April 10th, 2008 15:00

3100cn Network Problem With Vista

Hi gang,

 

My network is set up like this: DSL rounter connects to Lynksys wireless router which connects to wired switch. All computers as well as the 3100cn are connected to the network through the switch and file sharing and internet access works fine. I use the wireless router for my Blackberry and laptop.

 

I have two XP and two Vista machines. The XP machines can access the 3100cn but the Vista machines cannot. The 3100cn firmware is up to date as are the drivers on the Vista machines. I can ping the 3100cn from the Vista machines. I tried to run the setup disk that came with the printer on a Vista machine but the setup program froze so I used the 'Add Printer' method from Control Panel.

 

As an aside, I had the printer connected to the switch AND to one of the XP computers via USB and was having trouble using it from the XP machine until I disconnected the USB cable. Don't know what that is all about.

 

Thanks for any ideas.

 

Steve

  • llynster

    2 Intern

    •

    1700 Posts

    183

    0

    Posted April 10th, 2008 17:00

    If you can ping it, it's obviously being seen on your network.

     

    One thing you said that caught my eye is that you tried installing the drivers on your Vista PC using the CD. I'm pretty sure yur CD does not have Vista drivers on it.

     

    Have you downloaded the latest Vista drivers from here ?

  • SteveP55419

    106 Posts

    183

    0

    Posted April 10th, 2008 18:00

    Ilynster,

     

    Thanks for shoving me in the right direction. Yes, I had the right drivers but I didn't go about installing the thing the right way. When I first ran the installation disk, it hung but there were no Vista drivers on the computer at that time.

     

    Before I made the original post, I had installed the printer using the Add Printer method in control panel (with the correct drivers) but that did not work obviously. So after your post I ran the installation disk with the good drivers on the machine. It ran OK. Then I installed the printers from the print dialog (Notepad > File > Print) and it worked. I installed both the PS and PCL printers that way. The installation disk did not automatically create the windows printers for me as it did in XP. I do not know if I would have had success installing them from Control Panel but it doesn't matter. My printers work.

     

    Thanks again.

     

    Steve

  • llynster

    2 Intern

    •

    1700 Posts

    183

    0

    Posted April 10th, 2008 18:00

    Not sure I helped much, but glad you're printing again.