UNSOLVED

Moussa.Dell

updated

4 months ago

MD

Moussa.Dell

1 Rookie

•

1 Message

•

4 Points

0

129

July 30th, 2026 11:45

Dell TL2000 iSCSI Connectivity Issue – iSCSI Ports Not Detected and No Network Traffic

Hello,

We have been using a Dell TL2000 for several years to handle our backups, and we have not experienced any issues until now.

For the past few weeks, our server has lost the iSCSI connection to the TL2000. The connection keeps trying to reconnect in a continuous loop, but the library management interface remains fully accessible.

We have observed the following:

  • From the server, the iSCSI interface IP address no longer responds to ping, while the management interface is still reachable.
  • We connected a workstation directly to the iSCSI ports in order to analyze the network traffic, but we cannot see any network activity at all, even using Wireshark.
  • We performed a network scan on both iSCSI ports, but no device was detected.
  • We also tested the default IP address of the iSCSI card, but it does not respond either.
  • The LED next to the USB port is blinking, while the RJ45 port LEDs are lit, which seems to indicate that the physical link is established.

Could you please provide some guidance or suggest any additional troubleshooting steps we could perform?

Thank you in advance for your help.

  • DELL-Josh Cr

    Community Manager

    •

    9792 Posts

    •

    45323 Points

    0

    0

    Posted July 30th, 2026 16:55

    Hello,

     

    Thank you for the detailed description of the issue and the thorough troubleshooting you have already performed. Based on what you have described, this does point strongly toward a hardware failure of the iSCSI bridge card installed in the TL2000.

     

    The fact that the management interface remains fully accessible confirms that the library itself is functioning normally, as the management network connection is handled separately from the iSCSI interface. The iSCSI connectivity in the TL2000 is provided by a dedicated bridge card, and when that card fails, you would see exactly the behavior you are describing: no ping response, no network traffic visible even on a direct connection with Wireshark, and no detection during network scans, all while the management side continues to work without any problems.

     

    The RJ45 LEDs being lit can sometimes be misleading, as the physical Ethernet PHY on the card may still negotiate a link at the hardware level even if the card's processor or firmware is no longer functioning correctly. So the link lights alone do not necessarily confirm that the card is healthy.

     

    Before concluding that the card has failed, there are a couple of things you could still try. First, you could power cycle the entire library, not just a restart from the management interface, but a full power down, wait about thirty seconds, and power it back up. Sometimes the iSCSI bridge card can get into a hung state and a full cold boot may recover it. Second, if you have access to the library's management web interface, check whether the iSCSI configuration page still shows the expected IP settings, as it is possible that the card reset its configuration, though this would be unusual after years of stable operation. You could also try resetting the iSCSI card configuration to factory defaults through the management interface and reconfiguring the IP settings.

     

    If none of that restores the iSCSI connectivity, the bridge card has most likely failed and will need to be replaced. I would recommend contacting Dell Technical Support to confirm the diagnosis and to arrange for a replacement card. When you contact them, have your service tag ready along with the details you have shared here, as it will help expedite the process.

     

    Please let me know if you have any questions or need further assistance.