UNSOLVED

dcmbrown

updated

3 months ago

D

dcmbrown

15 Posts

0

5196

November 14th, 2005 15:00

Oops! Accidently created volume... want RAID 1!

I have a PowerEdge 1800 with the SATA CERC 6 channel RAID card. After installing and evaluating various Linux flavors I finally settled on RedHat and then installed the OS, set up all of the data on the system needed, and was just about to test the RAID failover capabilities when I realized I made an oops!

I must have deleted the array before I installed the final OS and ended up creating a volume instead of the RAID 1 I had intended! Is there a way to duplicate the disk without losing the data and convert it into a RAID 1 array (with the other disk involved)?
  • Eric BY

    2 Intern

    •

    815 Posts

    93

    0

    Posted November 16th, 2005 13:00

    Depending on the current disk configuration, how many free disks you have, and if you are using LVM, maybe.

    If you are using LVM and have free disks available, you can migrate your logical volumes between your physical volumes.

    If you aren't using LVM, and you have free disks available, you can create the new container, then offline, (Red Hat rescue mode), you can migrate the data between the volumes.

    If you don't have free disks, your out of luck, and will need to start over. 

    In the Enterprise environment, I would default to LVM, unless there is a need not to.
  • eRazZzeR

    4 Posts

    93

    0

    Posted November 30th, 2005 12:00

    The RedHat KB has articles on this.

    http://kbase.redhat.com/faq/FAQ_43_2812.shtm

    Hope this helps. And please let me know the result.