pyxfluff

updated

7 months ago

P

pyxfluff

1 Rookie

•

2 Posts

•

2 Points

0

281

April 5th, 2026 07:03

R630 can't clear dead PERC battery alert

I bought a PERC H730p without a battery (for now; I do plan on installing one eventually) for my PowerEdge R630. However, every time the system POSTs it says that there is no battery in the system and that I can clear the warning by pushing a button. However, no matter how many times I click the key, my LCD is still orange and I still see the alert at every POST. Additionally, I get a new error logged every boot. Can this be solved?

  • DELL-Joey C

    Moderator

    •

    4170 Posts

    •

    20965 Points

    0

    1

    Posted April 8th, 2026 04:09

    Hi,

     

    This is expected behavior, and no, you cannot permanently suppress the warning while the battery is missing on a PERC H730p. Dell treats a missing Cache Protection Module (CPM / battery) as a persistent hardware fault, even if you don’t want to use write‑back cache.
     

    When no battery is present the controller forces Write‑Through cache but during POST, it still reports “Battery missing”.

     

    There is no way to disable or suppress the alert permanently, even if you configure the controller not to use caching. 
     
     

    DELL-Joey C

    Social Media and Communities Professional

    Dell Technologies | Enterprise Support Services

    #IWork4Dell

    Did I answer your query? Please click on ‘Mark as Accepted Answer’ if I did. 

  • Dell-Martin S

    Moderator

    •

    3883 Posts

    •

    25810 Points

    0

    0

    Posted April 7th, 2026 13:28

    Hi,

    Your screenshot shows repeated `The PERC1 battery has failed.` entries, which is consistent with the controller detecting a missing or failed battery on every boot rather than a one-time stale message.

    The orange LCD and new boot log entry each time are therefore expected behavior while the controller still believes the backup battery is absent or failed 
    you could do these steps:

    - Reseat the controller and check the battery connector/cable path if a battery/BBU is actually connected, because Dell notes detection issues can come from a removed, unseated, or non-communicating battery, not only a dead one .  
    - Update the PERC firmware and iDRAC firmware, because Dell support notes that firmware can affect battery reporting and transient false failures .  
    - Clear the system event log after fixing the underlying issue; clearing logs alone will not stop the warning from returning if the hardware state is unchanged .

    with kind regards Martin/ Liebe Grüße Martin

    Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!

    DELL-Martin S

    Social Media and Communities Professional

    Dell Technologies | Enterprise Support Services

    #IWork4Dell


  • pyxfluff

    1 Rookie

    •

    2 Posts

    •

    2 Points

    0

    0

    Posted April 7th, 2026 16:10

    @Dell-Martin S​ Hi, thanks for the reply. The PERC does not currently have a battery installed, my question was if I can get iDRAC to stop saying the battery has failed every time. In the server BIOS there is a warning that says to push a key if there is no battery installed but when I push the key nothing happens.

    (edited)