UNSOLVED

riad63

updated

12 years ago

R

riad63

3 Posts

0

33870

August 8th, 2014 18:00

PowerEdge 1950 Will Not Turn On - Amber Light Flashes twice

Last week I installed a USB 3.0 PCIe-X1 card and powered the card using an external MOLEX power supply. The card worked great and was recognized by my Windows 2012 server. I tested it with an external USB Hard drive and it worked great. Today there was a power outage and I found that the server had rebooted and halted with the following error: PCIe Training Error: Embedded ......... System Halted ! I Hard rebooted the server to see if it would go away and the error still occurred. On the third Attempt, the server would no longer power on. The LCD flashes Amber twice and displays no message. When I push the power button, nothing happens. Both power supplies seem OK since the green lights are on. These are the steps I took to on avail: 1) Removed the PCIe-X1 USB card 2) Removed the PCIe riser and reseated. 3) Tried the RESET Jumper 4) Replaced CMOS battery 5) Unplugged the server from power and pushed the power button for 20 seconds as someone suggested to drain memory power. At this point I ran out of ideas. Any suggestions out there would be greatly appreciated.
  • riad63

    3 Posts

    678

    0

    Posted August 8th, 2014 22:00

    UPDATE. I took both PS out and put another one from another PE and I was able to boot. Somehow these two PS stopped working. This time I was able to see the error: PCIe Training Error: Embedded NIC 2 System Halted! I turned it off and let it cool down for a bit, activated the NVRAM Jumper. Rebooted. Shutdown and change jumper back to default. Rebooted. Was able to get to the BIOS. Disabled NIC 2. Rebooted and got the error again. After trying several things I pretty much gave up. I fell the NIC CHIPS on the motherboard and they were unusually burning HOT. Long story short, I have a feeling that the PCIe X1 USB 3.0 Card somehow caused the PCIe controller to fry. My question to the experts is: Do you thing the PCIe USB 3.0 card caused the problem or was it the power outage. Funny thing is that I have an APC UPS battery backup. So, I am clueless as to what could have caused the PCIe controller to malfunction and the PS to go BAD.
  • theflash1932

    11 Legend

    •

    16255 Posts

    678

    0

    Posted August 9th, 2014 10:00

    That is the nature of electronics ... it can be working just fine, sometimes even on the very edge of functional/non-functional, then it suddenly stops ... sometimes it doesn't take any more than simply applying (or removing) power when starting up (or shutting down) to put it over the edge.  Of course, non-validated hardware can cause issues when one or both companies did not work together to ensure full compatibility, which is why in, say, the server or business workstation world, it is common to have compatibility lists to ensure something like that doesn't happen.  Also, the power supply is designed to regulate and distribute power, making it more susceptible than its downstream components to power fluctuations.