Whilst trying to update firmware on PE2900 for the above RACs i have noticed on a high percentage that the firmware will not apply as it cannot get the state of the card. issuing a reboot also brings up an error saying rac communications failed.
The only solution is have had so far is to reseat the ribbon connectors on the card power up and all seems ok and able to apply firmware. as most of the machines are at remote sites running v1.0 of firmware this is going to be quite a hassle to upgrade all the others.
has anyone else come across this, or any suggestions as to reinitialise the state of the rac without reseating the connections?
Rac firmware is on base version 1.0 and trying to flash to 1.32 which i have managed to do on other servers. the BMC is on base version as i'm running updates that don't require a reboot yet, i.e rac and SAS.
I understand that you are trying to perform updates that don't require a reboot. If possible for your next couple of machines update the BMC first, then perform the DRAC update. It's not the desired order but may prevent you from having to reset the connections.
duffer26
22 Posts
232
0
Posted March 26th, 2008 21:00
Rac firmware is on base version 1.0 and trying to flash to 1.32 which i have managed to do on other servers. the BMC is on base version as i'm running updates that don't require a reboot yet, i.e rac and SAS.