UNSOLVED

TT7

updated

20 years ago

T

TT7

1 Message

0

7253

May 23rd, 2007 09:00

Boot Problem after upgrading BIOS from A05 to A09 on PowerEdge 2400

My PowerEdge 2400 started beeping continuously and based on a possible solution to system error message I had, I upgraded BIOS from A05 to A09. After that it won't boot. After many different attempts to solve this problem, this is the situation now: - no more beeping : ) - At the very first screen at boot, "A09" is shown. - When I press F2 or F10 at boot, it says "Entering Setup" or "Entering Utility Mode", but actually nothing happens, and the boot process continues until below and stays here. "1 Logical Drives found on the Host Adapter. 1 Logical Deive(s) handled by BIOS" - I don't know if this failure existed before the BIOS update, but I cannot boot from Floppy because: "Diskette 0 drive 0 seek failure" - The CD is detected, but it won't boot from it and continues on with "normal" boot process. "A BOOTABLE CD-ROM IS DETECTE IN YOUR CD-ROM DRIVE... The boot sections on your bootable CD-ROM are: 0. DEFAULT ENTRY" Can someone explain what happened to my BIOS and/or how I can boot this server again(Windows 2003)? Thanks a lot.
  • NetFodder

    12 Posts

    257

    0

    Posted May 25th, 2007 02:00

    I hate to be the bearer of bad news but in the old 2400's there was an update to the way the system managed the disks. Basically by upgradeing to the new bios the disks aren't read the same. I never got a full answer from dell about the whole thing but I had 2 diferent methods for fixing the machines. If all else failed I had to reinstall. The other option is to do an inplace upgrade. Boot from your windows cd. The first message is to ask if you want to install or repair. Hit escape to install. That repair would only work if you had the windows repair disk and still would only work if the disk config was the same and it's not anymore. So you get the EULA and hit F8, the setup then does a scan on the disk and MIGHT find the existing OS and will ask you if you would like to do another type of repair at this point. It basically does an upgrade even if the OS has newer service packs on it but it has to be the same base version win2k, win2k3, XP.... So You'll see it do the upgrade and after it's done you will need to go to windows update to run the updates and service packs. If you're running things like exchange on 2k3, once the inplace upgrade finishes the exchange will fail. Do the service pack upgrades and the exchange will come back online.