UNSOLVED

hadshep

updated

23 years ago

H

hadshep

21 Posts

0

10468

March 23rd, 2004 11:00

Belkin Netsetup

Dell Dimension - XP Home Ed.

Product - Belkin Starter Network Kit F5D9001
Devices are working properly on both machines (slave machine is not Dell)
I have disabled 1394 Net Adaptor and MAC Bridge Miniport
Realtek  RTL 8139 Family PCI Fast Ethernet NIC is enabled
With the XP machine, when I select Belkin NetSetup I get the message
"You have more than one Network Adaptor Installed"
All I want to do is access the hard disk on my Windows 98 machine and share a printer

  • _Paladin

    795 Posts

    153

    0

    Posted March 23rd, 2004 12:00

    hadshep,

    Rather than using the Belkin setup software, you can configure your two PC network manually using the tutorials here.  Follow the links for setting up a TCP/IP file sharing network.  Note that you are setting up a peer-to-peer network; all the PCs are peers.  There is no master or slave.

    The Belkin network kit is two ethernet adapters and a crossover cable.  More than likely the Dimension came with an ethernet adapter already installed - most new PCs have them as standard equipment.  If you installed one of the Belkin cards as well, that would explain the error message you are getting.  You can safely remove the Belkin card and connect the crossover cable to the adapter that came in the Dimension.  Then follow the tutorials.

  • hadshep

    21 Posts

    153

    0

    Posted March 24th, 2004 12:00

    Thank you Paladin - will give it a go!
  • hadshep

    21 Posts

    153

    0

    Posted May 15th, 2004 09:00

    There is no socket on either machine that the Belkin crossover cable will fit. I have followed instructions as advised on homenethelp.com but cannot get the computers to "talk" to each other. All I want to do is use the older machine as a second hard drive.
  • _Paladin

    795 Posts

    153

    0

    Posted May 15th, 2004 13:00

    hadshep,

    You indicated the Dell Dimension had an RTL 8139 NIC.  That is an ethernet network adapter (also called a network interface card) so you don't need to install one of the Belkin cards in the Dimension.  The connector for the RTL 8139 should be in the back of the PC, in the general vicinity of the USB connectors and the other external connectors.  If you specified which model of Dimension you have more specific information is available.  The connector looks very much like a modular telephone connector, but somewhat larger to accommodate 8 pins instead of 4.

    The second PC (also undefined) probably needs to have one of the Belkin cards installed.  Follow the installation instructions that came with the networking kit.

    Follow HomeNetHelp's tutorials here.  You will need to assign a static IP address to each computer.  This is done through the TCP/IP properties of the respective network adapter.  Assign IP address 192.168.0.101 to one PC and IP address 192.168.1.102 to the other.  Each PC should be set up with the same subnet mask: 255.255.255.0.

    Of course, an alternative to all this is to remove the HDD from the old PC and install it as a slave drive in the Dell Dimension.